Part Number: ADS7066 Tool/software:
Hello,
I am using ADS7066 as a SPI slave in single mode. Can you please help with the following question, suppose if I do below steps.
>> Sending bytes through SDI
>> Getting output from SDO
…
Part Number: ADS7066 Hi Team, seeking some support.
Using the ADS7066 for a data acquisition application. I have a MAX41400 amplifier for 10uV-10mV(5Hz-5KHz) signal amplification and this goes to the RC(kickback) filter before the input of the ADC.…
Part Number: ADS7066 Hi team,
As mentioned, could ADS7066 support 5 pcs in daisy chain mode?
Does the communication sequence used as follow? Each byte need a s eparate CS control signal?
Best Regards,
Will
Part Number: ADS7066 Hi Team,
Can you provide a little bit more information on the ADC Offset Calibration function on the ADS7066?
Are there any expected input conditions that we need to hold when we initiate the offset calibration, or is it an internally…
Part Number: ADS7066 Hello,
What's the state of ADS7066's SDO pin while the AVDD (analog supply) is off but the DVDD is on? It looks the SDO level is still High and disturbs SPI communication of the other SPI slave devices on a shared SPI bus.
In…
Part Number: ADS7066 Hello,
If I am running in auto-sequence mode, do I need to clock 0x00 into SDI for every transfer, or are certain bits “don’t care” like they are during On-The-Fly mode?
Part Number: ADS7066EVM-PDK Other Parts Discussed in Thread: ADS7067 , ADS7066 Hi,
I have the Evaluation board of ADS7066, and also I have ADS7067.
I wanted to ask if it is possible to still use the TI GUI after replacing these two ADCs on board?…
Part Number: ADS7066 Hi E2E,
Good day.
What is the maximum number of ADS7066 devices that can be daisy-chained and how can we calculate it? What are the factors that prevents from increasing the number of daisy-chained devices?
Regards, Carlo
Part Number: ADS7066 Hello,
I'm trying to get the ADS7066 running on a new design, and I've come across an issue that I can't figure out.
On the front page of the datasheet, it says that full throughput can be achieved with a SPI frequency >4.5MHz…
