Other Parts Discussed in Thread: ADS7263 Hi
I am using ADS7263 with PIC32 SPI interfaces. Using In MODE 4, with external Reference.
Can u help me to use commands to initialize ADS7263???
M unable to get any data from ADC.
My busy bus is going…
Hi Kawai,
Unlike the RD input on the ADS7263, the CONVST input does not need a clock edge to be recognized. The sample and hold switch opens with the application of the CONVST, going from sample to hold mode, regardless of the SCLK input. The actual…
Other Parts Discussed in Thread: ADS7263 Hi Team,
Please tell me in case if there is a problem, if the clock pulse for ADS7263 is not continuous.
CLK pulse is intermittent as attached.
Thank you for your support in advance.
Best Regards, Kawa…
Other Parts Discussed in Thread: ADS8363 , ADS7263 , ADS7223 , ADS7863 Hi engineers:
In ADS7263 datasheet page 17：With tACQ = 100ns, the minimum bandwidth of the driving amplifier is 19MHz for the ADS8363, 17MHz for the ADS7263, and 15MHz for the ADS7223…
Hi Tom
Thank you very much for the answer.
I wouldl ike to doble check.
if the below table works for our input signal condition, Unipolar (0 ~5V) using internal refernce (2.5V).
and if it is same for ADS7263 as well sa ADS8363
http://e2e.ti…
Other Parts Discussed in Thread: ADS7263 Hello,
I am trying to interface with an ADS7263 using an ACTEL FPGA and I am not having much luck with it. I am pretty sure that I am able to program the registers, but I cannot get the device to convert properly…
Hi Xavier!
Welcome to the e2e forum! If you only have the two summation channels, it would be easier to use the fully differential mode of the ADS7263 taking the 2.5Vref to the (-) input. If you intend to use the reference outside of the ADC, it is…
Other Parts Discussed in Thread: ADS7263 Hi,
We have obtained questions from our customers as follows.
Q1. Difference of Half-Clock Mode and Full-Clock Mode What is the difference of half-clock mode and full-clock mode? We think that the minimum data…
Hi,
We have a question regarding analog input impedance. We found that there are descriptions of analog input impedance on page 4, 16 and 17 of the data sheet. Could you please tell us the maximum and the minimum regarding C PAR , C S , R SER and R…
Other Parts Discussed in Thread: ADS7263 In the ADS7263 Data sheet (SBAS523B –OCTOBER 2010–REVISED JANUARY 2011),
In the Reference and Common Mode Selection(REFCM) Register section(Page 27), Under the Table 12 the mentioned point is
"(1) This register…
