Other Parts Discussed in Thread: ADS7824 Hello,
I am currently working on ADS7824 and i have made the circuit according to the data sheet. I am getting the output but am unable to check whether the output is write or not.. i am using internal reference…
Other Parts Discussed in Thread: LMP91000 , ADS7824 Hello,
I am doing very low-power EVM board for blood gluscose monitoring application including LMP91000 AFE, ADS7824 (low power ADC) and MSP430.
I am starting my work from EVM seen in ti.com for…
Hello Stephen,
Welcome to the precision data converters forum!
In both single and continuous modes, BYTE value must be changed to read all 16bits using the parallel bus.
To setup continuous conversion mode and read data, you could do the following…
Hi Peter,
Have noticed similar with EK-TM4C1294-XL launch pad ADC noise is quiet high +vRefA directly tied to +3v3. The odd thing is a good part of the sample noise was coming from +5 feeding +3v3 LDO assume the MCU internal 2v0 LDO.
The launch pad…
All very good advice yet LP at this time ADC channels are open inputs simulating analog rising steps driven by residual AXi input gate E charging (Csh), (Rsw) internal resistor and capacitor. Must point out none of that added motor discussion has to do…
