Part Number: ADS7950-Q1 Other Parts Discussed in Thread: ADS7950 Hi, I am using ADS7950 to detect temp and voltage, i got 3 failed PCBA, can read value, but not correct, power off for a long time, restart again, still fail.
after re-solder the same…
Hi Abhjieet-san,
I have additional request.
I found an article at the URL below.
e2e.ti.com/.../using-sar-adc-tina-models-much-ado-about-settling
I think that we can estimate accuracy or settling time by simulation like Fig.2.
Could you tell…
Part Number: ADS7950-Q1 Hello,
I'm master course about IC Design in Chung-Ang Univ. in South Korea.
I research about 'Wide Supply Range SAR ADC', but I don't know about why this specification are needed.
I know about automotive supply condition…
Hi Manoj,
An interactive version of the block diagram that was in the application note can be found at this link: http://www.ti.com/solution/battery-management-system-bms?variantid=14012&subsystemid=17238
As far as ADCs for this application I would…
Part Number: ADS7950 Other Parts Discussed in Thread: TLV1570 , TMS320C6742 , hi Expert,
My existing project design is using McBSP to interface between TLV1570 and TI DSP TMS320C6742 as following
But TLV1570 is entering LTB status now. So I am planning…
Hi Victor,
See the following parts:
Part Number
Description
Resolution (Bits)
Sample Rate (max) (SPS)
# Input Channels
Multi-Channel Configuration
Input Range (Min) (V)
Input Range (Max) (V)
Interface
Integrated Features
…
Joseph,
Thank you for your advice. For ADS7950, they need a ADC device which has roughend leadframe. It doesn't seem that ADS7950 supports it.
Can you review one more if ADS7142-Q1 will be okay for the application (two analog inputs (3.3V), single…
Part Number: ADS7953 I am currently trying to program an ADS7953 for Manual mode (no GPIO pins for SDI or SDO) and Alarm setup of GPIO1 for low alarm and GPIO0 for High alarm. But Alarm frame programming has a few incomplete and confusing details. Grouping…
