Hi Aaron,
Thanks for your support.
Please see the feedback as below.
Aaron Estrada said: Is the customer using an EVM or their own custom board? If using a custom board, can you pleases provide a schematic?
Using their own custom board. Please find the…
Part Number: ADS7951-Q1 Other Parts Discussed in Thread: ADS7951 Hello.
There are some problems when I use read data from ADS7951 by SPI, and SPI baud rate is 500KBPS.
The application is battery management system and ADC reference is 2.5V.
Normally, all…
Part Number: ADS7951-Q1 Hello. I have raised a recent writing a while ago.
I have additional questions.
The phenomenon occasionally reads the ADC output to 5V.
Out applications are BMS(Battery Monitoring System) and system diagram is as follows.
…
Part Number: ADS7951-Q1 Other Parts Discussed in Thread: ADS7951 Hello,
We are using ADS7951 device to read some analog measurements in a high power inverter application.
We are working with AUTO Mode-1 for reading the information.
Without PWM applied…
Part Number: ADS7951-Q1 Hi Team, Our customer is requesting the leakage current of the pin numbers 1,2,29 &30 pins (Digital IOs) of ADS7951-Q1 since it is not available in the datasheet. Can you provide this information? If not, the input impedance for…
Part Number: ADS7951-Q1 Other Parts Discussed in Thread: ADS7951 Hi,
What is the unused pin recommendation for unused ADC input channels and unused GPIOs for ADS7951?
Also what to do with the NC pins(pin 15 and 16).Should it be grounded via zero ohm resistor…
Part Number: ADS7951-Q1 Other Parts Discussed in Thread: ADS7951 , ADS1018 , HI Team,
What's the SPI pin status(the SCLK, SDI, SDO pin status specifically) for the ADS7951 when the CS is not selected(CS high)?
Are they HI-z or 0 or 1?
And also same questions…
Part Number: ADS7951-Q1 Other Parts Discussed in Thread: ISO7721 Hello All,
1.what is the Ti recommendation for ADS7951-Q1 ADC for the below pins?
1.Unused GPIO
2.NC pins
3.Unused ADC Channel
2. what is the Ti recommendation for unused channel in the…
Part Number: ADS7951-Q1 Hi, Team,
My customer want to increase the input filter cap from 150pF to 1nF to avoid the system noise. Is there any risk for this application? We can't find any suggestion for this cap, pls help check it. Thanks!