Part Number: ADS7952-Q1 Dear Sir:
Regarding the ADS7952-Q1 Issue.
1. MULTIPLEXER :CH0~ CH11.
No Use channels. It can float these pins.
Is it correct?
2. NC PINS: Pins(Pin11~14) internally not connected, do not float these pin
It needs to connect…
Part Number: ADS7952-Q1 We are doing a production run of one of our products. This particular design calls for the ADS7952SRHBT, however it is out of stock everywhere and extremely difficult to find. The ADS7952-Q1 is available. Apart from the package…
Part Number: ADS7952-Q1 Other Parts Discussed in Thread: ADS7953-Q1 , Hi Team,
ADS7952-Q1 was mass production in our customer. Due to supply issue of ADS7952-Q1, customer start use ADS7953-Q1.
Is the software of ADS7952-Q1 compatible with ADS7953…
Part Number: ADS7952-Q1 Hi team,
Customer asked me a question, i f 2*VEF > VA, what will be the effect on ADC. For example, VREF=2.7V, VA=5V.
Looking forward to your reply as soon as possible
Thanks.
Sveinn
B R
Part Number: ADS7952-Q1 Hi,
I am using ADS7952 in manual programming mode, with analog and digital supply of 5V and separate AGND and DGND connected at one point, Vref=2.5V. In manual mode, I am not able to select range 2 (0- 2*Vref), 2.5V input to…
Part Number: ADS7952-Q1 HI team,
My customer is considering the front-end RC filter 47kohm & 1uF at the input pin, to have a very low cutoff frequency, any potential risk? Like lower settling time, or will it affect the measurement accuracy heavily…
Part Number: ADS7952-Q1 Hi team,
I plant to use ADS7952-Q1 with VA=5V, Vref=5.0V (2.5V x2 mode)
If VA drops below Vref voltage like 4.8V,
1. Is there any reliability issue?
2. What is the output code at this condition? Will it overflow?
…
Part Number: ADS7952-Q1 Other Parts Discussed in Thread: ADS7952
Hi,
I am using ADS7952 in manual programming mode, with analog and digital supply of 5V and separate AGND and DGND connected at one point, Vref=2.5V. In manual mode, I am not able to…
Part Number: ADS7952-Q1 Other Parts Discussed in Thread: ADS7952 Hi,
I have an ADS7952 chip with the following hardware configuration:
+VA: 5V
+VBD: 3.3V
REFP: 2.5V
Channels 4-11 in use, channels 0-3 unused
GPIO unused
When I start…
Part Number: ADS7952-Q1 HI Team,
I'd like to know what's the SDO output status when device power up?
And also if the SDO goes to tri-state when the CS is pulled high? Can we confirm that the SDO will not output high level when device power up and…
