Part Number: ADS7953
Tool/software:
Hello, we are using ADS7953 to collect the voltage and current values inside the circuit board. There is an abnormality with one of the circuit boards 1. The default state U1 is very hot, 10W. 2. After removing…
Part Number: ADS7953 Tool/software: Hello! I haven't been able to find any explicit power-on or power-down sequencing requirements for the ADS7953 in the datasheet. The "Recommended Operating Conditions" specify +VBD should be less than +VA, but the Absolute…
Part Number: ADS7953-Q1 Tool/software: Hello TI Team,
For our weight balancing on PCB, we would request you to share the precise mass for the part below.
ADS7953-Q1
Thanks, in advance!
Regards,
Part Number: ADS7953-Q1 Tool/software: Dear Expect:
Current problems:
1. There are two AD conversion chips on the board, one of which has four pins of GPIO0~GPIO3 suspended in the air and can read data normally, but there is a small induction waveform…
Part Number: ADS7953 Tool/software: Hi, I have some questions about ADS7953 SPI sequnce.
I have set ADS7953 in Auto1 mode and if the CS falling edge aligns with the SCLK falling edge, or if SCLK is high when the CS falling edge occurs, does this conform…
Part Number: ADS7953
Tool/software:
Is there anyone I can email a schematic of the ADS7953SBDBT for design verification before I do a board spin? Pretty simple 1 page design but would like to be sure everything looks good.
Part Number: ADS7953 Hi team,
could you help with below question for ADS7953?
is it necessary to use LDO to power VA/VBD/VREF? can we use the DCDC to power? and can we use one rail for these pins?
Part Number: ADS7953 Tool/software: Looking to use the ADS7953SBDBT and interface it with USB. What's the easiest way to do that and how big of a firmware lift is it? Had been considering USB to SPI bridge using the FT2232H-56Q-TRAY, but figured TI has…
