The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: ADS7953-Q1 Tool/software: Hi,
Can I get the failure rate (FIT) for this device (ADS7953QDBTRQ1)?
I am using the Motor Control mission profile based on IEC 62380 (Table 11 - Mission profiles for automotive). Mean temp ~60 deg C.
Preferred…
Part Number: ADS7953 Tool/software: I am attempting to communicate with the ADS7953 in manual mode using the RM57Lx microcontroller with mibspi. However, I seem to be only getting nonsense values on the SDO. My baud rate is at 1000 kHz
I've attached…
Part Number: ADS7953-Q1 Tool/software: Hi,
I am using device ADS7953QDBTR1 with RM57Lxx MCU.
Do you have example(or reference) source code for this device driver?
Thanks,
James
Part Number: ADS7953 The datasheet's Figure10 shows that the current increases as the sampling rate increases.However, the test found that in the power down mode, the current of the chip VA was very small. Even if the input clock speed was changed…
Part Number: ADS7953 I have ADS7953 and ref4132-3.0v.
The power supply voltage of my system is 5V and the reference voltage is 3.0V.
If the ADC input signal is 4.0 Vpp,
I have problems for these 2 cases
1) 1xVref
Does digital output is full scale 0xFFF…
Part Number: ADS7953-Q1 Hi team,
Could you tell me the analog input maximum value? In my understanding, this max value is 5V even in both range1 and range2. Ultimately, I'd like to check if this ADC can observe 12V signal directly.
Best Regards…
