Part Number: ADS7955-Q1 The MUXADC transfers the correct values for channels 0 to 6 after a reset. The reset signal (0x1840 & 0x4200) is sent by the CPLD (orange marking in the oscilloscope capture). However, channel 6 then gets stuck and is continuously…
Part Number: ADS7955-Q1 Other Parts Discussed in Thread: ADS7955 Hi there,
I selected ADS7955-Q1 for my application due to cost and temperature grade of 125C. For this ADC, my application consists of measure 6 battery cells (ranging from 10.5V to…
Other Parts Discussed in Thread: ADS7955-Q1 Hi,
we are planning to use the 8ch devices of the ADS795x Familiy in an automotive application. Its a module design, so we plan to interchange the 8bit, 10bit and 12bit version depending on requirements. …
Part Number: ADS7961-Q1 Other Parts Discussed in Thread: ADS7961 , ADS7955 Tool/software: I combines Renesas microcomputer RH850 and ADS7961 After power up, configure the device/ADS7955 to operate in manual mode without any other configuration. You are…
Part Number: ADS7953 I am currently trying to program an ADS7953 for Manual mode (no GPIO pins for SDI or SDO) and Alarm setup of GPIO1 for low alarm and GPIO0 for High alarm. But Alarm frame programming has a few incomplete and confusing details. Grouping…
