Part Number: ADS7960
Hello,
I am having trouble getting any data on the SDO output of my ADS7960, and I would like to ask for your assistance.
I have already tried all operating modes: Auto-1, Auto-2, and Manual. The device is properly powered,…
Part Number: ADS7960 Hello,
The following is the schematic diagram of ADS7960. Could you please help me check if there are any issues? Can GPO0-3 pins float? Thanks.
Part Number: ADS7960 Hi,
I am trying to program ADS7760. I have following questions.
1. The power up flowchart on page 31 (Figure 29) says that we have to set the device in manual mode in frame 1, Auto 1 register program on frame 2, Auto 2 register…
Part Number: ADS7960 Other Parts Discussed in Thread: ADS8860 Hi,
I have used the above part and was successfully written/read using 16-bit transfer mode. However, when I tried to do the same with 8-bit transfer mode, it doesn't seem to work. The only…
Part Number: ADS7960 I have met some trouble when i set the function mode of ADS7960SDBT. According to the datasheet, as my understanding, if i want the device work in auto-1 mode,i need firstly send [0010 1000 0100 0000 ]into sdi to set the model control…
Part Number: ADS7960 Hello Guys,
Good day.
Aside from the IBIS model, do we have available spice model for ADS7960?
Are there any simulation model from a similar part that can be use?
Thanks and regards,
Art
Part Number: ADS7960 This package is designed to be soldered to a thermal pad on the board but should I add additional pin in the symbol designed to connect the thermal pad? if so should I connect it to GND? the datasheet doesn't specify it.
Part Number: ADS7960 THE CHIP SPEC talks about N-1,N,N+1 and N+2 implying there is a single frame delay from selecting a channel to output of the channel, but Figure 1. implies a longer pipelined process First Frame the host sends the channel N on SDI…
Other Parts Discussed in Thread: ADS7960 at the ADS7960 there are NC pins with the description "Pins internally not connected, do not float these pins"
I don't understand, to connect them or not, Why to connect them if they are not connected internally…
