Search tips
Showing 17 results View by: Thread Post Sort by

  • ADS805: About VDRV power

    Part Number: ADS805 My system is divided into analog and digital circuit blocks. I want to keep the analog circuit block powered while shutting off the power to the digital circuit block. In that case, I would be shutting off the VDRV (+3.3V) power supply…
    • Answered

  • ADS805: Is ADS805 a pseudo differential input ADC?

    Resolved
    Part Number: ADS805 Hello everyone! Is ADS805 a pseudo differential or fully differential input ADC? I can not find this information in the datasheet. https://www.ti.com/product/ADS805 Thank you!
    • Resolved

  • ADS805: Input RC design constraints

    TI Thinks Resolved
    Part Number: ADS805 Does ADS805E have any restrictions on the RC design of the input end? Since the minimum hold time is 3.9ns, Is there any conversion formulas for the RC at the input? Thank you Tony Liu
    • Answered

  • ADS805: ADS805 Development Kit Avaliability

    Resolved
    Part Number: ADS805 Where would I purchase the DEM-ADS80xU Evaluation Fixture.
    • Resolved
    • Answered

  • ADS805: What is the Tconv for ADS805

    Resolved
    Part Number: ADS805 I am also looking at using Texas Instruments ADS805 on page 4 of the datasheet there is a table that states Tconv Min =50 Max =100us and ns not sure if this value is us or ns
    • Resolved
    • Answered

  • ADS805: What is the Convert Clock Period

    Resolved
    Part Number: ADS805 I am also looking at using Texas Instruments ADS805 on page 4 of the datasheet there is a table that states Tconv Min =50, Max =100us and ns not sure if this value is us or ns
    • Resolved

  • ADS805: input current

    Part Number: ADS805 I have the device configured for internal reference with a 0-5V input range. (SEL to ground; IN_N to Vref). I am using AC coupling with IN_P to 0.45V using a 2K to ground and 20K to +5V. When I power up the device IN_P goes to 0.45V…

  • RE: ADS805 offset

    Sorry folks, I'm an idiot. I was powering +5V from a CMOD_A7 board and I was powering that off a USB connection. To make matters worse, that "+5V" was then being filtered. The result was ~4.4V at the +5V input. When I changed things to bring the ADS805…

  • ADS805: will work with a

    Part Number: ADS805 If i give a 3Vp-p sine wave input signal from a function generator,the output will get with reference to common mode voltage or 0V??? i have connected the ADS805 as attached image file. Thanks Eashwar

  • ADS805 Heat dissipation

    Other Parts Discussed in Thread: ADS805 Hi, I am using 4x ADS805 on a pcb with layout spacing of approximately 21x21mm square. With a ambient temperature of 25 degrees celcius, I measure the temperature on the IC at 50 degrees celcius after a while. The…

Didn't find what you are looking for? Post a new question.