Part Number: ADS8320 I was referred here by TI Customer Support. I have been validating a new product of ours that uses the ADS8320E/250 ADC and I am having some problems with the accuracy. When I graph the input voltage going into the ADC and compare…
Part Number: ADS8320 hi dear supporting team,
customer is using ADS8320 with below sch(share the same circuit with AD7683). They found there is close to 1V glitch at Vin pin, which has same cycle with Cs signal. the input is disconnect with previous stage…
Part Number: ADS8320 Other Parts Discussed in Thread: ADS8860 , ADS8860EVM-PDK Dear Sir / Madam,
I am using ESP32_devkitc_v4 board for my electric motor predictive maintenance project. I am using accelerometer (ADXL1002Z) to measure vibration data from…
Part Number: ADS1131 Other Parts Discussed in Thread: ADS8320-HT , ADS1278-HT , ADS1278 Tool/software: Hi,
I am in the need of high temperature application i am in the need of ADCs and ADC Mux IC above 150C.
With 24 bit resolution or greater than 12bit.
…
Part Number: ADS8320 Other Parts Discussed in Thread: ADS7056 Currently, I am working on a project where I’d like to use the ADS8320 A/D convertor. The only remaining open issue is the choice of reference voltage. Therefore I have some questions regarding…
Part Number: ADS8320 Hello Community,
On page 33 of the document attached, there are two equations with respect to a pole and zero being produced. Since this forms an LPF RC filter, the 1/ReqC makes the pole understandable, but I don't understand where…
Part Number: ADS8320 Hello,
I'm currently using the ADS8320 in one of my designs. However, I have a question about the configuration of the external RC filter. Does this have to be a differential filter, like stated in the layout example as the first…
Part Number: ADS8320 I'm interested in using this part to sample at 400Hz. Figure 23 in the datasheet shows the power consumption down to 1kHz. Does the curve continue to fall linearly (by 2.5x) if I sample at 400Hz, instead of 1kHz. Is there a static…
