Part Number: ADS8332 Hi,
Let me ask you a basic question as below.
1) When we set "Auto-Trigger" mode (CFR register, D9=0), the sample rate setting (CFR register, D8) will be ignored, correct?
2) In case we use "8ch" input, the max sampling rate…
Part Number: ADS8332 Hi,
I would like to ask you a question about the setting of sampling rate.
In case of using "default setting", that is to say, CFR register is "FFF"h setting,
the sample rate is determined by "CONVST" signal timing.
For example…
Part Number: ADS8332 Other Parts Discussed in Thread: REF6050 , REF02 Hi,
I try to use an ADC ADS8332 with SPI communication.
It seems to be work great.
I am able to configure the CFR register (the config is 0b011111111111);.
I tried also to read…
Part Number: ADS8332 Hello,
I am using an ADS8332 for my application.
My question is the following:
Can i drive the device with 5 Volts at the analog supply VA and 3,3 Volts at the digital supply VBD?
Or do i have to drive them with the same…
Part Number: ADS8332Ads8332 abnormal heat, power configuration after the completion of the pin pull high CLK will have a chance of abnormal heat, seek explanation
Part Number: ADS8332 Hi,
I have interfaced ADS8332 with TM4C123 on SSI2.
Configured clock at 20MHz.
Writing to configuration register CMR + CFR = 0xE7BD. (proded on oscilloscope)
But reading back CFR with 0xC000 I am not getting back 0x7BD.
…
Part Number: ADS8332 LSB( 0- 3bit) of conversion result of IN4 is always 0x03.( Result is 0x8b83 or 0x8bc3 )
INPUT = 1.65V (D.C.) REF = 3V AVdd = 3.1V DVDD = 3V
Manual trigger mode
Channel select is used
Even if IN4 and IN3 are replaced ,…
Part Number: ADS8332 Other Parts Discussed in Thread: TMS320F28335 Respected sir,
I am trying to find the interfacing example for ADS8332 ADC with tiva (or any other ) micro controller. I know that it is in control suit but i am not able to find it…
Part Number: ADS8332 I'm trying to talk to a single ADS8332 over 16 bit SPI, the host is a Cortex M4. I'm using internal CCLK and manual channel select & trigger, monitoring EOC.
I can't understand from the datasheet, the correct sequence to read the…
