Hi Kato,
The ADS8341 does not have any specific power on reset state which is why BUSY is sometimes held low at power up. If it does not respond properly after you initialize the device with your desired commands, that would be cause for concern.
Part Number: ADS8341 I am testing ADS8341 recently. I found out that DOUT is always HIGH.
Any method or solution would be appreciated.
CHANNEL1 : DIN
CHANNEL2 : BUSY
CHANNEL3 : DOUT
CHANNEL4 : DCLK
Part Number: ADS8341 Other Parts Discussed in Thread: ADS8684A , ADS8168 , ADS8684 Hello,
I am new with working with DAQ systems, I am currently working with the LIS344ALH accelerometer which has a resolution of 50 (ug/Hz-1/2) and a dynamic range of +-2g…
Part Number: ADS8341 Hi TI Engineers and all,
I’m using ADS8341 in my meter application.
Problem:
1. The conversion result is always even number, LSB bit is always 0.
Output result: 240; 246; 244; 62 862; 62 868; 62 864… etc
All other…
Other Parts Discussed in Thread: ADS8341 Hi all,
Customer is evaluating ADS8341 now and find following output data collapse with the condition as described below.
Power supply +VCC: +5VDC Vref: +4VDC Input voltage for CH0 - CH3: 0 to +4V
If input 5V into…
Other Parts Discussed in Thread: ADS8341 Data sheet specs say min 4.5 clk cycles, internal clock freq 2.4 MHz. But timing diagram, figure 6 shows acquisition time as 4 cycles of DCLK which is a lot slower in my case. Which is it? Trying to design the input…
Hi Jishnu,
No, you can not change the BW of internal LPF. Also, when you use this ADC to measure a high frequency signal (e.g. 15kHz), your signal will be attenuated and distorted by the LPF. There are two possible solutions:
1. Use an ADC with integrated…
