Part Number: ADS8344EVM Other Parts Discussed in Thread: ADS8344 , Hello
I'm trying to connect ADS8344 EVM with ATMEGA128.
But I'm not sure how to config for the Power, GND and lots of Fuses.
Please let me know which setting is correct once external…
Part Number: ADS8344 Hello,
I'm debugging a problem and need a little help understanding the ADS8344 SPI bus. Figure 4 (page 13 of the datasheet), indicates two things:
DCLK must be low during the falling edge of the chip-select (CS#) event. …
Hello Andrew,
If certain channels are not being used on the ADS8344 , then through the digital communicaiotns, they can not be converted. You can use the Control Byte, shown in table 3 of the datasheet , to be sure that the unused channel is not sampled…
Part Number: ADS8344
Hi, a customer has reported a strange issue with the ADS8344 after the product has been subjected to an ESD spike.
he's what happens
1: Initially, ADC working normally
2: ESD spike applied to products external analogue lines…
Other Parts Discussed in Thread: ADS8344 Hello,
I am using Atmel SAME70Q21 MCU SPI interface to write into ADS8344, I have the following questions that I was wondering if you could please help me.
1) Do you have any code samples for this configuration…
Other Parts Discussed in Thread: ADS8344 Hello everyone, I have one problem which is inconceivable to me. I have read very much documents about ADC's before i make a final design for my board. There wasn't any description about that one problem. So here…
Other Parts Discussed in Thread: ADS8344 Hello.
I'm using ADS8344 to digitize signals from the pressure sensors.
After assembly, to assess the quality of the board histogram of codes was obtained:
The resulting histogram has many peaks that occur…
Other Parts Discussed in Thread: ADS8344 , REF3330 Hello.
I have two design with ADS8344 and the output creates a lot of noise / jumps, app 64 counts.
The other thing is that the output jumps at 16 count and only gives 2, 4, 6 etc in the last digit…
Other Parts Discussed in Thread: ADS8344 Dear all,
We’ve got a question concerning the use of TI ADS8344NB 16-Bits Analog to Digital Converter.
In our design, the ADS8344 is used to monitor a few thermal sensors and the board power supplies (3.3V…
