Search tips
Showing 64 results View by: Thread Post Sort by

  • ADS8353-Q1: Total Noise Calculation of ADC

    TI Thinks Resolved
    Part Number: ADS8353-Q1 Hi We are doing the noise analysis of ADS8353QPWRQ1 in which we are trying to calculate the total noise of the ADC system. We are performing the analysis based on the TI-precision-labs video: https://training.ti.com/ti-precision…

  • ADS8353-Q1: maximum acquisition time

    TI Thinks Resolved
    Part Number: ADS8353-Q1 Hello there, about the acquisition time, the EC table says that the maximum acquisition time is tacq=33*tCLK-tconv= 33*50ns-730ns=920ns (when 20Mhz, dual SDO mode) however, in figure 7-6 the tacq start at the end of tconv…

  • ADS8353-Q1: SPI SDO data launch edge

    Part Number: ADS8353-Q1 hello there, my test result of SPI SDO data latched edge is opposite with the datasheet. my test shows that the SDO latch edge is the rising edge of SCLK. however, the datasheet(figure 7-7. and table 10) say that the latch…

  • ADS8353: Digital noise on ACQ

    Part Number: ADS8353 Hello, I use the ADS8353 in Single SDO mode 32CLK, depending of the level of signal, I have digital noise. An STM32 microcontroller is used for this, with a D flip flop to correct the phase shift of SDO output of ADS8353…
    • Answered

  • ADS8353: Vref Noise Ripple

    Resolved
    Part Number: ADS8353 Hi Team, This is customer request can you please support: " Can you provide noise-ripple information for the DAC used in the internal voltage reference of this integrated? " Thanks in advance Best Regards
    • Resolved

  • ADS8353: ADS8353

    TI Thinks Resolved
    Part Number: ADS8353 hi, 1. Datasheet, page 39, the first 16 pulses when reading the converted data, What data should SDI specifically write? 2. Datasheet, page 38, in the timing of reading the register data, how many numbers of pulses is N? …

  • RE: ADS8353: ADS8353 Output Drifting with consecutive measurements

    Not sure why it removed the link I pasted... According to www.ti.com/.../slyp166.pdf , the 1nF RC cap should be fine since it is >20x the 40pF S/H cap of the ADS8353. Thus, I think the problem might lie with the resistor creating a large time constant…

  • ADS8353: warm up time required?

    TI Thinks Resolved
    Part Number: ADS8353 Hi Team, Customer is asking if this device has any warm up time requirement so can meet our accuracy/drift spec? Thanks! Andrew

  • ADS8353: SUPPORT SOFTWARE ADSxx53EVM-PDK

    Part Number: ADS8353 Hello, We purchase two ADSxx53EVM-PDK and after installation of the application software, the application hangs with the message "Loading Application" . My computer runs windows 10 Pro edition. I need to be able to run the SW…

  • ADS8353-Q1: Input Impedance of Analog IO pins.

    TI Thinks Resolved
    Part Number: ADS8353-Q1 Other Parts Discussed in Thread: TINA-TI Hai, How do we calculate input impedance for Analog Input Output pins of ADS8353QPWRQ1?

Didn't find what you are looking for? Post a new question.