Part Number: ADS8365 Tool/software: Hi,
We are using ADS8365 in our project. We have used all 6 input channels and shorted all 3 Hold signals and making it low for one clock cycle to start the conversion.
We are reading the channels one by one by…
Part Number: ADS8365 Other Parts Discussed in Thread: ADS7864 , ADS8363
Tool/software:
Hi TI,
In my custom board ADS8365 ADC is selected, but size is not feasible on my board.
So, Could you please suggest ADC part number which Simultaneous sampling…
Part Number: ADS8365 If HOLDA, HOLDB, and HOLDC are all low for one clock cycle at the same time, will EOC output three pulses? Is there a case where EOC is not output even if a pulse is input to HOLD?
Part Number: ADS8365 Is there a change of the device marking?
Order code is: ADS8365IPAG
Device marking according to Datasheet is ADS8365AI
On our last production charge 02/2019 there is a device marking ADS8365I
Is this correct?
Part Number: ADS8365 Other Parts Discussed in Thread: ADS8364 Hi team,
My customer was using ADS8365. But now, they want to change ADS8365 to ADS8364. So just want to check with you that can ADS8364 directly replace ADS8365 without changing any hardware…
Part Number: ADS8365 Dear Sir,
I read the datasheet of ADS8365 and find out it only provides 250k and 100k sampling rate. Is there any method to change the sampling rate, say 2k, by hardware?
Hi,
You mentioned SDRAM interface here but what you need is ASRAM (ASYNC interface). For ASRAM you do not need clock and you should be able to control the access time by programming SETUP/STROBE and HOLD values.
Regards,
Vivek Singh
Other Parts Discussed in Thread: ADS8365 Hi all,
Reading the PDF datasheet of the ADS8365, I find an inconsistency that I cannot solve.
On p.10, I can read:
"An external CMOS compatible clock can be applied to the CLK input to synchronize the conversion…
Other Parts Discussed in Thread: ADS8365 We're using several ADS8365 parts spread across a 15" long board. Unfortunately, the board has been designed with one long trace running between the ADCs for each of the digital side control lines HOLDXn, RDn,…
Other Parts Discussed in Thread: ADS8365 , ADS8364 , ADS8568 HI,
When I watch the Figure 1(attached file) at the datasheet of ADS8365, it is written that CS line is pulled down at CONVERSION TIME.
Is it necessary to pull down CS at CONVERSION TIME…
