Part Number: ADS8661 Other Parts Discussed in Thread: ADS8665 Hi,
In "Device Transfer Function", the FSR/2 code is 0x800. From this table, the expected value code at 5.12V is 0x800.
Also, in Figure 6-19, the output code for input = 5.12 V is…
Part Number: ADS8661 Hi Team,
May I ask a question about ADS8661, in the datasheet, sampling frequency is 1.25 MSPS, but input bandwidth is only 15k.
Previously I used another ADC IC which sampling frequency is 500ksps and –3dB Input Linear Bandwidth is…
Part Number: ADS8661 Other Parts Discussed in Thread: ADS8861 ,
Hi Team,
I want to check the procedure of reading voltage by using ADS8861. Would you help check below procedure for us? Thank you.
Platfrom : Raspberry Pi, SPI speed, = 15.25878906kHz
SPI…
Part Number: ADS8661 Hello,
I am using stm32h7, and I am able to read 12 bit ADC values from ADS8661 IC through HAL_SPI_Receive() as shown in the code (per loop it is taking 13us), but when plotting and calculated the sampling rate, I am only able to…
Part Number: ADS8661 Other Parts Discussed in Thread: ADS8688 Do u have the IBIS module of the ADS8661 or some similar ICs for us to use? We want to have the IBIS module of ADS8661(8 daisy-chain) to go through the SI simulation。 Thank U.
Part Number: ADS8661 Hello,
I've been looking up at driver files for this IC [ADS8661] couldn't find it online. I am trying to develop it with STM32H7 . If someone has created it please share it .
Thanks and Regards,
Vibeesh
1. Done.
2-1.
Q: I'm curious why you are sending only 7 SCLKs instead of 12 or 16 SCLKs to the ADC every time.
A: When using dual SDI MODE, SDI single only exists in the first 6 clock cycle. I use 7 clock cycle to speed up conversion, last clock cycle…
Part Number: ADS8661 Other Parts Discussed in Thread: ADS8688 , ADS8674 , ADS8665 Hi All,
I bought a ADS8661 . I want to program this device but I couldnt find any Application Note for development. Is there any example or any code for the program.
Th…
Part Number: ADS8661 Hello,
I am trying to work with the device but with no success, the datasheet is not clear enough.
1) I am using SPI MODE0.
2) I am sending data in 8bit data groups (same when receiving data) ie sending 8 clocks at a time, hence for…