Part Number: ADS8671 I configured the ALARM/SDO-1/GPO pin as an alarm by setting SDO_CTL_REG bits 9-8 to 01b per table 7-14 (SDO_CTL_REG Register Field Descriptions).
I would like the GPIO pin to function as an active alarm for the alarm input and go…
I have not received your response for almost one month, this thread will be closed. I hope your issue has been solved. You can post a new query if you still have any questions. Thanks.
Part Number: ADS8671 Hello Ti Team,
I am working with the ADS8671 ADC and I couldn't find anything on how the data should be interpreted or what is needed to set up the ADC.
So I have two questions.
1. If I do not write anything to the ADC and just…
Part Number: ADS8671 Other Parts Discussed in Thread: ADS8900B Hi TI Team,
Thanks for your continuous supporting for my queries.
I am using ADS8671 and ADS8900B in my design.
How can I read the converted data equivalent to the analog signal to be converted…
Part Number: ADS8671 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Hi TI Team,
I am looking for an ADC for measuring 0-5V in 1mV resolution so the required bit is 13. for this requirement I think this part will be better…
Other Parts Discussed in Thread: ADS8671 , ADS8685 , ADS8689 My design receives a -38V to -60V voltage input over a long cable (100 ft - 300 ft). This board will have an MCU with/without ADC on it. I want to measure incoming negative voltage and communicate…
Part Number: ADS8671 Dear Expert.
Thank you for your special support everyday.
There is a simple question about ADS8671 IPW.
What is the slew rate value of PGA (programmable gain amplifier) ?
Other Parts Discussed in Thread: ADS8671 Hi TI Team,
I am happy to contact you after a while.
This is an urgent requirement. I am looking for an alternate part to ADS8671 . I was used this part for 0-5V measurement and I very much satisfied with this IC…