Part Number: ADS8688EVM-PDK I am trying to connect the ADS 8688 EVM to my Pi through SPI. I have used two methods to power on the ADS8688EVM. 1. Through PDK 2. Without the PDK After connecting the miso-sdi, mosi-sdo, cs-cs and sclk-sclk on the two respective…
Part Number: ADS8688EVM-PDK Other Parts Discussed in Thread: ADS8688 Hi
We have connected the ADS8688EVM to AST2600EVB(Processor) through SPI interface. Even after enabling the drivers in kernel and in device tree, the chip select is always high.…
Part Number: ADS8688EVM-PDK Other Parts Discussed in Thread: ADS8688 The EVM GUI plots time domain data in volts using 3-digits of precision. To better represent the ADC codes at least 6 digits is required. The software user guide (SBAU230C – AUGUST 2014…
Part Number: ADS8688EVM-PDK Other Parts Discussed in Thread: ADS8688AT We recently received an evaluation board kit for ADS8688AT and after installing software that goes with it, I am not able to pass the "Connecting Hardware".
I can see the LED2,3…
Part Number: ADS8688EVM-PDK Hi Experts,
Where do I download hardware design file for ADS8688EVM-PDK?
Include mechanical file, Layout files and CAD files.
Thanks a lot.
Derek
Part Number: ADS8688EVM-PDK Hi.
I have a same issue with following question.
ADS8688EVM-PDK: sdcc interface not detected
I figure that this issue may solved by sdcc driver.
Could I get a same driver please?
Best Regards
Murata.
Part Number: ADS8688EVM-PDK Hi,
When i try to connect the ADS86XX EVM to hardware a message " SDCC Interface not detected " is shown.
PC reffered the device as generic bulk device
can you please share the Windows10 version driver to me with install…
Part Number: ADS8688EVM-PDK Other Parts Discussed in Thread: ADS8688 I have a few question on diffrent ways to control ADS8688EVM both with and without the PHI board.
I plan to control the ADC with a FPGA specifically sbRIO-9637.
With PHI Board…
Part Number: ADS8688EVM-PDK I have an older rev ADS86xxEVM that had missing SD-Cards. after downloading the latest EVM software i was about to get the SDCC to start and PHI to operate with the GUI software but it hits an error window stating "In Get EVMEEPROM…
Part Number: ADS8688EVM-PDK Other Parts Discussed in Thread: ADS8688 Hi All,
We are using ADS8688 EVK Kit. Replaced TI Controller with our own controller and configure like below. We are seeing any data. Timing parameters and SPI Mode are followed…
