Part Number: ADS8694 Tool/software:
I am putting ADS8694 in one of my design.
The input is bipolar from -2V to 2V. and i am using the internal reference 4.096V with input range setting 0.625 x 4.096= +/-2.54V.
out of 18 bit data output 16 bit are…
Part Number: ADS8694 Other Parts Discussed in Thread: ADS8689 Tool/software:
I am putting ADS8694 in one of my design.
The input is bipolar from -2V to 2V. and i am using the internal reference 4.096V with input range setting 0.625 x 4.096= +/-2.54V…
Part Number: ADS8694
Tool/software:
What is the correct way to read the AUX IN channel .
1. Power up the device. 2. Once the device is properly powered up, RESET the device registers by sending command 0x8500 on the SDI line. 3. Select the Manual…
Part Number: ADS8694 Dear Technical Support Team,
I have a question about "ts" in "7.6 Timing Requirements" on page 10 on the datasheet of ADS8694.
The ADS8694 has "Command Register" and "Program Register". "Command Register" has an access time of…
Part Number: ADS8694 Hi Team,
My customer came with following question:
The ADS8694 (18-bit, 500KSPS, 4 channel SAR) seems to have a 2 nd order anti-aliasing LPF with a bandwith limitation of 15KHz. Is this hard-coded limit?
Part Number: ADS8694 Hello,
I am wondering if I am not using Alarm function, how do I tie this pin or left it floating/NC?
I understand that RST/PD pin must always have a defined state , if I am not going to use Reset function, do I hard tie this…
Part Number: ADS8694
Hi all,
Looking at the State Transition Diagram in Figure 79 on page 39 of the data sheet, it is a diagram that allows the state transition from AUTO mode to PROG mode. However, the datasheet does not mention this state transition…
Part Number: ADS8694 Dear Technical Support Team,
Let me check the power supply and GND. Q1. According to Fig.109 in data sheet, AVDD and DVDD seem to use the same 5V power supply. Does it mean that the same power supply can be used? Q2.
Is it okay…
