Part Number: ADS8860 In the attached image i understood offset calibration, But was slope itself is called gain error
In the above example were both gain error and offset error are calibrated ?
since incase of DAC there are different formulae for…
Part Number: ADS8860 Other Parts Discussed in Thread: OPA320 Tool/software: Hi TI,
Please help to share the Tina files explained in the "Hands-on experiment: Amplifier settling and charge bucket filter design" session Under SAR ADC input driver design…
Part Number: ADS8860 I have two questions regarding to 8860 reading
1. According to data sheet, it is a 16-bit ADC. But nowhere can I find info on how to convert 2 bytes to voltage. The following is how I do conversion:
adc_8860_val = a_SPI1_3_RxBuf…
Part Number: ADS8860 Hi,
I use ADS8860 in my PCB. Most of time the reading is as OK as expected.
However, occasionally the two-bytes result is completely 0; and once it occurs, it remains 0 forever until I reset the whole PCB.
Can anyone enlighten…
Part Number: ADS8860 Other Parts Discussed in Thread: ADS8861 Hi team,
We can saw that our ADS8860 is for single-ended input.
But the pin have AINN & AINP, is that means this device can also use for differential input?
Which one do we recommend…
Part Number: ADS8860 Other Parts Discussed in Thread: ADS8695 , ADS8318 , ADS117L11 , ADS8685 Tool/software: Please could you suggest an equivalent TI part number for the Analog devices AD7988-5CCPZ
E.g. ADS8860IDRCR ?
Part Number: ADS8860 Hi Team,
I would like to ask for clarification for this video slide-7, how is it estimated that 130MHz BW is required for op-amp if no charge bucket filter is used?
Here is the video link: training.ti.com/ti-precision-labs-adcs…
Part Number: ADS8860 Dear team,
In the datasheet of ADS8860, It mentioned that the UGBW of the ADC driver should be 4 times larger than then 1/2piRfltClt, which is also mentioned in training video "The Math Behind the R-C Component Selection TIPL…
Part Number: ADS8860 Hello TI Team
Hello,
I am Dhiren presently working on 16Bit ADC ADS8860 which is interfaced with msp430 on its SPI lines of UCA2. I am using 3-Wire CS Mode Without a Busy Indicator where DI pin of ADS8860 is pulled up to DVDD…
