Part Number: ADS8867 Other Parts Discussed in Thread: ADS8317 Tool/software: Hello everyone,
I have found the ADS8867 because it almost perfectly meets the requirements that I have, save for the bipolar input range. Is anyone aware of another IC that…
Part Number: ADS8867 Other Parts Discussed in Thread: THS4521 Tool/software: Hi, I hope you're doing well.
I need to measure the current of a PWM signal with the following specifications:
Period: 0.02 seconds (50 Hz)
Pulse width: 450 microsecon…
Part Number: ADS8867 Tool/software: The ADS8867 is a 16 bit which has a very low LSB, about 70uV.
This value is very small compared with the offset error and gain error of the chip, even the typical parameter.
Does this mean if I want an accurate…
Part Number: ADS8867 Hi,
I have observed that first reading from ADS8867 by the 3-wire SPI interface, seems to be garbage.
Is this normally behavior or have I maybe missed something? See code read ex. below from the prototype.
Regards,
Peter
read…
Part Number: ADS8867 Hello I two problems using this ADC. First, the last data bits coming from the SPI are not stable, and second, the rest of bits doesn't really represent the input value.
The ADC has been soldered in a VSSOP to DIL adapter and…
Part Number: ADS8867 Hi,
I am designing a data acquisition chain around ADS8867IDGS, but before moving to next project phases I need to know whether or not the component will be in production for at least a decade from now and/or there will be pin2pin…
Part Number: ADS8166 Other Parts Discussed in Thread: PGA281 , , ADS8867 , ADS8924B Hi support forum
Question1: For the ADS8166 please look the attached design proposal and make a sanity check and let me know if there is any problem to use just one pair…
Hello Danny,
1) The fabrication facility was not acquired from Burr-Brown during the merger. It is an external manufacturer. The Mouser product folder has all PCNs issued for the ADS8320 device - www.mouser.com/.../ADS8320E-250
2) There has not been any…
Part Number: ADS8867 The input signal is normal. When the power is unstable, output is all 0.But when the power is stable, the output is still 0.If I disconnect all the power and re-plug in the stable power, the data output is normal，
Where AVDD DVDD…
Part Number: ADS8867 Other Parts Discussed in Thread: ADS8166 , ADS8866
Hi,I have some problems when developing with ADS8867.I can not get the correct ADC value in GPIO mode and SPI mode.
1/In GPIO mode.
Solution 1.
GPIO configuration：
DIN：Output Push…
