Part Number: ADS8900B Tool/software: Hello team,
Is there a specific power supply sequence for RVDD, DVDD, REFIN?
For example, is it possible to apply DVDD and REFIN first and then RVDD after 10ms?
Best Regards,
Austin
Part Number: ADS8900B Tool/software: Hi team，
for the ADC， just like the SAR adc，how can we know its noise bandwidth？ just use the internal RSH andCSH to set the
cutoff frequency？is this right？
Part Number: ADS8900B Tool/software: Good morning,
For a project, I need to minimize connections to and from the ADS8900. As there is no requirement for a specific conversion start time, I wanted to connect CS_N and CONVST together as shown in the minimum…
Part Number: ADS8900B Other Parts Discussed in Thread: ADS8860 Tool/software: Hi team,
q1,for the below TINA spice model . are the models of SAR and sigma delta keeping the same?
q2, how can I create such a model in TINA or PSIPCE? just like the Tacq…
Part Number: ADS8900B Other Parts Discussed in Thread: ADS127L11 , ADS131A04 , ADS1271 , ADS127L01 , ADS127L21 , TPS7A20 Tool/software: For a new project we are using capacitive sensors for very accurate height measurements (3mm range with nanometer resolution…
Part Number: ADS8900B Hi team,
One of our customer is experiencing some parameters that are not understood when using the pspice model simulation, could you please help explain:
Which pin of the digital output of this chip is Vsamp?
Why can't I get digital…
Part Number: ADS8900B Dear TI,
I plan to use the ADS8900B with an STM32L431KBU3. To optimize data throughput when operating with 1 MSPS, I want to use the enhanced multiSPI feature.
The STM32 supports quad SPI consisting of CS, CLK, and four IO, however…
Part Number: ADS8900B
Hi, I have developed a custom board for ADS8900B, according to shared schematic.
adc_01.pdf ref_conn_01.pdf
and following the correction provided from this thread
For communicating with ADC, what i understand from "data sheet…
Part Number: ADS8900B HI.
I am trying to do SPI communication with my ADS8900 custom board, my strategy is as follows.
1. with rising edge of sampling clock. CONVST pin is pulled low.
2. Host controller/ FPGA moniotrs the RVS pin for a rising edge.
…
Part Number: ADS8900B Other Parts Discussed in Thread: ADS127L11 Hi Teams,
Currently, My customer are very satisfied with the performance of the ADS8900B (20bit). However, currently they come with a question about the /CS signal.
They received an important…
