Part Number: ADS9110 Tool/software:
I use ADS9110 to collect data, and when the data gradually increases from 0.6V, it shows that the printed data is correct. However, when the data decreases from 0.6V, the printed data remains at 0.6V (the data…
Part Number: ADS9110 Tool/software: Hello,
I am looking for a ADC that is able to operate at 2MS/s but with the lowest possible clock frequency.
In my application, the signals are digitally isolated and a delay in the measurement is acceptable as…
Part Number: ADS9110 Hi expert,
I'm learning Precision Lab series video and have seen ADS9110 has been take as example. I have one question for relationship of digital code output vs. analog input: when will code 0000 become into 0001?
If we define…
Part Number: ADS9110 Hallo everyone, I need to interface the ADS9110. Our hardware developer wired the ADC like described in chapter 7.5.4.2. (Single Device: Minimum Pins for a Standard SPI Interface) But when reading the chapter 7.5.2 (Interleaving Conversion…
Part Number: ADS9110 Other Parts Discussed in Thread: SN74AXC4T774 Team,
Do we have plan for a 5V IOs version of the ADS9110? If not what would you suggest as voltage translator for 1.8V to 5V on the digital interface? Do we have SAR alternatives with…
Part Number: ADS9110 Other Parts Discussed in Thread: ADS9120 , THS4551 , OPA625 , PGA281 Hi,
we are looking for AFE with PGIA solution for ADS9110 and ADS9120 ADCs. General requirements are:
- gains: 1, 2, 5, 10 or 1, 2, 4, 8 - single-ended and differential…
Part Number: ADS9110 Hi Team,
What's the absolute maximum +/-Current into the analog inputs for the ADS9110? My customer needs to make sure they adequately protect the inputs from a fault event.
Thanks, Mitchell
Hello Billy,
I have performed an approximate simulation using a simplified reference load model for the ADS9110. Since the circuit involves several ADC’s, to avoid convergence issues of the complex circuit, I used a piecewise linear current source to…
Hello Markus,
Holding CONVST low when pulling RST high is not a hard requirement. In the case of a single control line for both /CS and CONVST, you can keep both signals HIGH, with SCLK low, when RST is pulled high and still get a full reset of the…
Hello Keith,
The customer wants to input 1MHz(Typ)~1.5MHz(Max) signal to ADS9110 or 9120.
If there is any problem about the frecuency signal input, could you please give me your comment?
It would be much appreciated.
Thank you and best regards…
