Part Number: ADS9110 Tool/software:
I use ADS9110 to collect data, and when the data gradually increases from 0.6V, it shows that the printed data is correct. However, when the data decreases from 0.6V, the printed data remains at 0.6V (the data…
Part Number: ADS9110 Tool/software: Hello,
I am looking for a ADC that is able to operate at 2MS/s but with the lowest possible clock frequency.
In my application, the signals are digitally isolated and a delay in the measurement is acceptable as the…
Part Number: ADS9110 Hallo everyone, I need to interface the ADS9110. Our hardware developer wired the ADC like described in chapter 7.5.4.2. (Single Device: Minimum Pins for a Standard SPI Interface) But when reading the chapter 7.5.2 (Interleaving Conversion…
Part Number: ADS9110 Hi expert,
I'm learning Precision Lab series video and have seen ADS9110 has been take as example. I have one question for relationship of digital code output vs. analog input: when will code 0000 become into 0001?
If we define…
Part Number: ADS9110 Other Parts Discussed in Thread: SN74AXC4T774 Team,
Do we have plan for a 5V IOs version of the ADS9110? If not what would you suggest as voltage translator for 1.8V to 5V on the digital interface? Do we have SAR alternatives with 5V…
Part Number: ADS9110 Hi Team,
What's the absolute maximum +/-Current into the analog inputs for the ADS9110? My customer needs to make sure they adequately protect the inputs from a fault event.
Thanks, Mitchell
Hi David,
Thanks for your question. This previous E2E post my answer your question: https://e2e.ti.com/support/data-converters-group/data-converters/f/data-converters-forum/1068570/ads9110-connect-cs-and-convst-together-generating-problems
Please let me…
Part Number: ADS9110 Other Parts Discussed in Thread: ADS9120 , THS4551 , OPA625 , PGA281 Hi,
we are looking for AFE with PGIA solution for ADS9110 and ADS9120 ADCs. General requirements are:
- gains: 1, 2, 5, 10 or 1, 2, 4, 8 - single-ended and differen…
Part Number: ADS9110 Other Parts Discussed in Thread: ADS9120 Hello guys,
One of my customers is considering using ADS9110 or ADS9120 for their new products.
They have the following question about the device.
Could you please give me your reply?
Q. What…
Part Number: ADS9110 The data sheet SBAS629B –OCTOBER 2015–REVISED JUNE 2017, chapter 7.4.1 says:
To exit RST state, the host controller must pull the RST pin high with CONVST and SCLK held low and CS held high, as shown in Figure 42. After…
