Hello Kabilan,
Take a look at these cookbook circuits. They show how to go from a single-ended input to a differential output, suitable for driving differential input ADC's.
http://www.ti.com/lit/an/sbaa264a/sbaa264a.pdf
http://www.ti.com/lit/an…
Part Number: ADS8910B Other Parts Discussed in Thread: OPA2625 , , OPA625 , THS4551 , ADS8329 , ADS9110 , OPA2328 , OPA862 , THP210 , OPA320 , THS4561 , LM7705 Hi
A quick question on the ADC input driver type for ADS8910B. In datasheet page 59, the…
Hi Udell,
In the TLA2518, there is only one ground pin for the chip. Hence when reading data during an ongoing conversion can result in reduction in SINAD in TLA2518.
This is not a limitation for the other devices mentioned in the app note. This is…
Part Number: ADS8900BEVM-PDK Other Parts Discussed in Thread: ADS9110 Hi guys
I am using ADS8900 / ADS9110 EVM-PDK. I installed the ads9110 and ads8900 software. But i can't be open. it will show:
And I update the device driver by the install software…
Hello Mr. Kang,
The schematics, board layout images, and Bill of Material are included in the ADS9110EVM-PDK user's guide.
We do not have any firmware for the EVM that we can share. You can use a standard SPI port with a single MISO input to transfer…
Part Number: ADS9110EVM-PDK Other Parts Discussed in Thread: ADS9110 , ADS8881 The EVM board for the ADS9110 has its input bandwidth limited to 160kHz by the LPF on the input amp, but the ADS8881 EVM board has its bandwidth limited to 1.6MHz. What is…
For the ADS9110 evaluation board ( https://www.ti.com/tool/ADS9110EVM-PDK), is it possible to use my own MCU to communicate with ADS9110?
It seems I can only test it with TI-provided software, isn't it?
I wonder how I can use it in my own testbed…
Other Parts Discussed in Thread: ADS8681 , ADS8900B , ADS8860 , ADS9110 , ADS7882 , ADS7886 , ADS8481 , ADS8411 Good afternoon. Now, I am considering the possibility of using your ADC in the development of our company's devices. The value of the maximum…
Part Number: ADS7945 Other Parts Discussed in Thread: ADS9110 , ADS9224R , ADS9234R , The transistion noise spec is 25uV which is approx .04LSBs. This seems remarkably low for a 2MSPS 14bit convertor - it is better than many (most?) 18 bit converters…
Hello Zhang,
The ADS8484 is still available, but we have much better parts for newer designs.
If you only need up to 1Msps and 18b, then ADS8910B is a very good device. If you need higher sample rates, then ADS9110 can operate up to 2Msps and 18b…
