Part Number: ADS9224R Other Parts Discussed in Thread: ADS9226 , ADS9234R Hey Team,
I have a customer that is trying to find a low noise 16-bit adc that runs at roughly 3 MSPS. For now, they are using the ADS9224R.
Might there be a cheaper or potentially…
Hello Jendas,
The LCR reference design linked uses the ADS9224R for output measurement. Specifically, the ADS9224REVM-PDK EVM was used which has THS4551 followed by ADS9224R. This set-up made it very easy to interface with the LCR reference board. For high…
Part Number: ADS9224R Other Parts Discussed in Thread: TINA-TI Hi Team,
A customer of mine has some challenges with the ADS9224R. Kindly see their situation here. Direct questions are at the end of the post.
We are using a ADS9224R dual ADC in a zero…
Part Number: ADS9224R Other Parts Discussed in Thread: ADS9234R ,
Hi,
I would like to confirm if the max sampling rate of 16 bits resolution for each channel of ADS9224R is 3Msps independently. How about ADS9234R?
Thanks.
Part Number: ADS9224R Hi team,
What's the meaning of Max spur(dBC) and Max spur(Hz) in ADS9224 GUI?
Maz spur(dBC)=20log(max_harmonic_rms/fundamental component_rms) ?
Max spur(Hz): the max harmonic frequency of input signal ?
Part Number: ADS9224R
We're developing an application where we want to sample the ADS9224 at 3MHz. Due to I/O constraints, we can only use a single data line per channel. This means we need to use a clock of 60MHz for clocking the data out of SDO-0/0A…
Part Number: ADS9224R Hi team,
I have two small questions about the design of external circuit of ADC. Hope to get your help.
How to design the capacitor in front of the input of ADC? ( 3300pF ) Are there any documents about it?
2. Are there any examples…
Part Number: ADS9224R The fact that the internal reference and reference buffers can be powered down tends to indicate that an external reference can be used. However, the data sheet only describes operating the part with the internal reference.
Part Number: ADS9224R 1) If I send a command to SDI that says I want to read a register (e.g BUS_WIDTH register), where would I see the output of that register, I wasn't able to find this info on the datasheet (not sure if I missed it)?
2) Every single…
