Part Number: ADS9226 Other Parts Discussed in Thread: THP210 We have been using ADS9226 for some time now, and we occassionally see cases where the part will output zero data (i.e. all data lines = '0') after a power cycle. Sometimes this affects both…
Part Number: ADS9226 Other Parts Discussed in Thread: ADS9224R ADS9226 ADC chip, using SPI to communicate with the MCU, each channel has two SDOs, no SDI, is it different from the standard SPI? Is it compatible with conventional SPI, i.e. SCLK, MISO,…
Part Number: ADS9226 Hello E2E,
I hope you can shore up my understanding on the ADS9226 and how many SCLK pulses are needed to complete a conversion. Looking at 7.4.4, is it a little unclear to me what impacts this number and how many clock pulses are…
Part Number: ADS9226 Other Parts Discussed in Thread: ADS9224REVM-PDK Hi team,
Are EVMs for ADS9226 available now? or Do you have plan for launching the EVM?
Best regards,
Hideki
Part Number: ADS9226 Hi,
Customer noticed that there is no typical application schematic for the device like for ADS9224 (Figure 80 in that datasheet) so wanted to see if there's plans for this to go with the example layout provided in the datasheet…
Part Number: ADS8681 Other Parts Discussed in Thread: ADS9226 Hi team,
If I have a differential output signal (voltage sensing from the AMC33x), and since this device has a single-ended input, how can I make use of the full dynamic range instead of…
Hello Dajon,
The sampling rate and noise requirements you provided are very vague. How low is "low noise?" A minimum SNR target would be helpful here.
I believe the ADS92xx family would be the best family of products to suggest if the customer is…
Hi Naveen,
The ADS9120 is a good alternative to ADS8861 if you need a lower conversion time (or higher sample rate). Both the ADS8861 and ADS9120 use a SPI compatible interface, but there are quite a few differences between these interfaces. You will…
