Part Number: ADS9817 Hello,
In the datasheet section 6.4.3, there is an Initialization Sequence described. When I look at Table 6‑10, I actually see two different versions of the sequence: one with 26 steps and another with 29 steps.
Could you clarify…
Part Number: ADS9817 Dear team,
During the use of ADS9817, it has been able to collect data correctly without any changes in the FPGA firmware, upper computer software, or hardware. However, there may be sudden anomalies in the data collected by individual…
Part Number: ADS9817 Tool/software: Hello,
I saw from one answer about this issue that the first table in the data sheet ADS9817 (table 6-10) is the correct Initialization table.
If you look at the table it uses incompatible register addresses in…
Part Number: ADS9817 Other Parts Discussed in Thread: ADS9212 , ADS9815 , ADS9811 , ADS9813 Tool/software: Hi TI-Team I am looking for the time tx between the sampling of the analog signals and the digital output of the sampled value of the ADS9817. Currently…
Part Number: ADS9817 Other Parts Discussed in Thread: ADS9813 , MUX36D08 , ADS9120 Tool/software: it's about ADS9817's sample rate.
In ADS9817's datasheet, there is saying "This overall system can achieve a maximum throughput of 2 MSPS/channel for all…
Part Number: ADS9817 Tool/software: Hello dear TI,
could you please explain why there are 2 initialization sequences in the ADS9815/ADS9817 datasheet (REVISED OCTOBER 2024) ??? (from page 31 to 33)
Which one is the right one ???
The second one seems…
Part Number: ADS9817 Other Parts Discussed in Thread: ADS9813 , Tool/software: Hello,
As mentionned in ADS9817 (and ADS9813) datasheet: "The ADS981x is an 18-bit data acquisition (DAQ) system with eight-channel analog inputs that can be configured as…
Part Number: ADS9817 Hi all,
What is the minimum amplitude width specification, like the minimum VID for the SMPL_CLKP and SMPL_CLKM pins during differential input? The data sheet also states the following:
"Clock amplitude impacts the ADC aperture…
Part Number: ADS9817 Hi,
There are 2 questions.
1. There is difference between output data and measured data
What point does customer check for this issue?
Test condition:
-Calibration Register ( GE_CAL_EN1,2,3) Disable
-ADC CH -> REF35120…
Part Number: ADS9817 Hi,
There are 2 questions.
1. what is MSB/LSB for effective 18bit of 24bit output? it seems to be D23~D6. is it correct?
2. Somtimes Ch2 or Ch3 data outputs firstly instead of Ch1 data on D3 and D2 line after rising of FCLKOUT…
