Part Number: AFE5801 Hi,
In my hardware. being designed for industrial application
this ADC part is sampling the baseband signal differential signal at 50MHz,
the mixer RF output differential impedance is 900 Ohms,
could you recommend me the…
Part Number: AFE5801 1.
In the AFE5801 datasheet page 19, SEN has a 100k ohm pullup resistor to DVDD18.
So the SPI port circuit of AFE5801 is powered by DVDD18?
RESET. SCLK and SDATA have a 100k ohm pulldown resistor to ground.
Can we connect…
Part Number: AFE5801 Dears,
By collecting ADC output through FPGA and simulating the output waveform with MATLAB, it was found that there were jitter and glitches. How to configure register adjustment?
The testing mode is normal.
In normal mode…
Part Number: AFE5801 Tool/software: Hi,
We are using AFE5801IRGCT, we are enabling only on channel, what is the current consumption on AVDD18, AVDD3 and DVDD18?.
Thanks,
Shilpa
Part Number: AFE5801
Hi,
In AFE5801, Is there any provision to use only one channel and disable other channels to avoid the current consumption?
Thank You,
Shilpa
Part Number: AFE5801 Hi Team,
A 200-kHz, 200-mVpp square wave generated by the signal generator couples a sine wave of the same frequency into the waveform output from the AFE5801. The customer would like to know how to remove this sine wave?
The…
Part Number: AFE5801 Hello
Regarding the AFE5801 Data Sheet page number 9, How to change between the Data Bit in MSB First Mode and LSB First Mode?
Roi
Part Number: AFE5801 Hi,
We are using AFE5801IRGCT with Altera FPGA, there is EVM and its data capture is demonstrated over TSW1400 FPGA board/GUI.
Please share get the ADC capture RTL code for our reference?
Thanks and Regards
Part Number: AFE5801 Other Parts Discussed in Thread: , DXP Hi
We are using three AFE5801 ICs in our board , All three IC are being fed a single ended clock of 40MHz from FPGA CLOCK pin through buffers.
We are enabling test patterns with SPI writes…
