Part Number: AFE7071 In the datasheet, I couldn't find the required signal levels for the input DACCLK. Can you please specify the expected signal levels? (LVPECL/LVDS/HSTL/CML etc.)
Part Number: AFE7071 Other Parts Discussed in Thread: LMX2572LP Hello,
I am working with your AFE7071. As has been recommended elsewhere on this forum, I am using the LMX2572LP as the LO input to the AFE7071. I have two boards that I am attempting to…
Part Number: AFE7071 What is the LO input power range for the AFE7071? The "electrical characteristics" section of the datasheet lists the range as being from -5dBm to +5dBm. The "typical performance plots" section of the datasheet seems to…
Part Number: AFE7071 Dear All,
I would like to ask about the AFE7071's Baseband filter characteristics.
In the data sheet, the filter characteristics are shown only specification table.
If you have the widest setting graph of filter characteristics…
JMT:
Good detective work on your end. Agreed, the register should return to High-Z state. I do not fully understand why this is not happening properly. It seems like this bit is getting "stuck" and requires a reset with toggling register 3b7.…
I am assume that you are referring to an LO source for the AFE707x. I recommend the LMX2572LP. This is a good low power synthesizer for use as an LO source.
--RJH
JH:
Yes, there are a couple of options that you can use to adjust the output control; however, you need to use these carefully because it will adjust the I/Q balance in the part and result in degradation in the sideband suppression and carrier suppression…
Part Number: AFE7071 Other Parts Discussed in Thread: LMX2572LP Is there any documentation available to assist selecting decoupling capacitors for use with the AFE7071?
Thank you