Part Number: AFE7906 Dear Team,
I have requested the AFE7906 Full datasheet through the link provided in the datasheet (raised on 10.11.25). Still the support access is pending stage only. Please provide the full datasheet for pin details and configurations…
Part Number: AFE7906 Other Parts Discussed in Thread: AFE7950EVM Dear Texas,
We have been working with the AFE development kit for some time now, carefully going through all the documents and guides - even asking questions via this forum. As the project…
Part Number: AFE7906 >Could you check that you are getting the Bytes correctly from your IP core?
>We have see other IP cores where there was a need to swap the Bytes
The IP core uses JESD204C from AMD's Vivado Design Suite Is there any precedent…
Part Number: AFE7906 Other Parts Discussed in Thread: TSW14J57EVM , AFE7950EVM , AFE7950 , , AFE7900EVM , AFE7900 Tool/software: We are developing a direct conversion system for X-Band Radar and, for this purpose, we are considering using the AFE7950EVM…
Part Number: AFE7906 Tool/software: Greetings, I am having troubles while trying to understand the correct way of configuring via SPI the NCOs in the AFE7906 ADCs in order to have the same phase for every new start of conversion I am performing. Is there…
Part Number: AFE7906 It seems that the Ramp test now works by configuring the following settings after "AFE.deviceBringup()". Data15:8 and Data7:0 look reversed Is this normal behavior?
### ADC Test Patterns
mode=2
# 0 - No Test Pattern # 1 -…
Part Number: AFE7906 Hi,
Greetings!
We are planning to integrate four AFE7906 with AMD's versal premium VP2802 SoC with the following configuration.
Sampling Rate: upto 3GSPS
Number of channels: 6
Bandwidth Required: 500Mhz.
In VP2802 SoC…
Part Number: AFE7906 Tool/software: Will this script support for dynamic NCOs switching in LATTE V2p6?
We are getting the following warnings in LATTE:
Max value allowed for numRxNCOB0/1 is 2. So forcing this value to 2. If 2 NCOs are needed, this…
Part Number: AFE7906
The FPGA and ADC1 (AFE7906) and ADC2 (AFE7906) are connected. I would like to configure the MUX as shown in Figure 1.
Output ADC input data of ADC1_1RX to ADC1_Lane1(3stx) Output ADC input data of ADC1_2RX to ADC1_Lane2(4stx)…
Part Number: AFE7906 Tool/software: Hi Texas,
We're building up our schematic using AFE7906 and as we are planning on using JESD204B mode 1-8-16-1-0 not all TX-/+ pins seems to be used, just 1 lane (differential pair) would be necessary, right?
…
