The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Hi Mr. Chen,
We tested this on our end, and using the following code to set TX1 NCO to 3800MHz, this worked for us:
updateTxNco(0,1,3800000,0)
Please try this on your end and see if it works for you.
Thanks! Aman
Part Number: AFE7921 Tool/software: Hi expert,
I have a question from customer needed for your help.
Can two channel of TX/RX of AFE7921 be configured as FDD and the other two channel be configured as TDD?
BR,
Zach
Part Number: AFE7921 Tool/software: Hi,
We had a new application,we used 2 AFE7921 for a total of 8TX 8RX and must to sync all TX channel and sync all RX channel.
And we try to reconfig AFE7921,but it can not works. We test all sysref and Dclk are …
Hi Aman,
We had some question about how to config AFE7921. We config AFE7921 with some error and found that the RX is OK but the TX is not good, and I read my FPGA,the 204B is linked.
The error log is below
first piece ad7921Config start...
first 7921…
Part Number: AFE7921 Tool/software: Hi,
We had some question about AFE7921.
Can AFE7921 have temperature sensor ?
Can I read AFE7921 temperature and how to read AFE7921 temperature.
Hi,
It seems like this is a duplicate question of this one here: https://e2e.ti.com/support/rf-microwave-group/rf-microwave/f/rf-microwave-forum/1415771/afe7921-some-question-about-latte-and-afe79xxevm_-gui-version .
Please refer to the above link.
Thank…
Hi,
There are one of most important question of the other post of JESD204.There are some other question of the old latte,see post e2e.ti.com/.../afe7921-some-question-about-latte-and-afe79xxevm_-gui-version
Part Number: AFE7921 Tool/software: HI,
We are using AFE79xxEVM_ GUIv1p10_ Installer on our board and we found the following problem, can provide AFE79xxEVM_ GUIv1p9_ Installer software for comparison?
1.If 204B is set to 48410, an error will be reported…
Part Number: AFE7921 Hi,
We had link AFE7921 to my FPGA,but we receive somany error codes.So we want to run PRBS to debug.
But we write register 0x4141 to 0xEB,and write register 0x4084 to 0xEE ,and then write register 0x4084 to 0xCE. There some question…