Part Number: AFE7950 Other Parts Discussed in Thread: LMK04828 , , Tool/software: Hi Akash,
The AFE79xx GUI will take care of configuring the FTDI device to program the AFE. The connection and configuration of the FTDI is done in the setup.py and…
Part Number: AFE7950 Tool/software: The AFE7950 data sheet is not sufficient for hardware design. I have been searching for a hardware designer's user guide. All I see are ap notes. Could you point me to a useful manual on designing this chip into a board…
Part Number: AFE7950 Tool/software: Hi, I have 6 RX paths in my design. According to the AFE7950 datasheet, the device supports 4 RX ADCs and 2 Feedback ADCs. If I configure the 2 Feedback ADCs to operate as standard ADCs, giving me a total of 6 RX channels…
Part Number: AFE7950-SP Other Parts Discussed in Thread: AFE7950 Tool/software: Dear Sir,
We are working on AFE7950 Script for both RX and FB channels working.
1.In ADC We are Planning to use the 4 nos of lanes for Rx channels(ie 4 channels) and 4…
Part Number: AFE7950 Tool/software: Hi,
I am trying to configure the AFE7950 EVM board with AFE79XX Lattice GUI.
For FadcRx, Fref and Fdac, if I am giving the values as shown below and run the buffer I am not getting any error :
sysParams.fbEnable…
Part Number: AFE7950-SP Tool/software: Hi,
does the AFE7950-SP support decimation of the ADC-data, e.g. reduction of bit-resolution from 14bit downto 10bit and so forth?
Thankd for the answer
BR
Part Number: AFE7950-SP Other Parts Discussed in Thread: AFE7950 Tool/software: Subject: Inquiry About Bare Die Availability of AFE7950 for Custom SiP Integration
Dear Texas Instruments Support Team,
I hope this message finds you well.
We are exploring…
Part Number: AFE7950 Tool/software: Hi,
We have developed JESD204 IP and testing it on KCU105 integrated with AFE7950.
1. AFE latte script shows AFE configuration complete and DAC JESD link status successful. We connected DAC output channel to signal…
Part Number: AFE7950-SP Other Parts Discussed in Thread: AFE7950 Tool/software: Dear team,
As per the AFE7950 guide lines ,recommended to maintain the separate ground for Analog supplies and digital supplies.
But in the EVM-AFE7950 separate ground…
Part Number: AFE7950 Tool/software: Hi,
I want to clarify the MAX Full scale input power - reliability limited, at device pins at RX spec table. Max. input power was specified with DSA=20dB. Is this DSA value automatically triggered by reliability RF…
