Part Number: AMC1210 Other Parts Discussed in Thread: AMC1306M25 Tool/software: When I use stm32f429vit6 spi to read AMC1210, I first write the 0x01 register 0x0001 value, but I cannot read it. miso is always in a low state when I read it. Could you please…
Part Number: AMC1210 Tool/software: We are trying to synchronize the delta-sigma acquisition with our internal PWM cycle and we were wondering if the ack signal is periodic or not.
Assuming that the ack signal is periodic, by using the same clock (the…
Part Number: AMC1210 Other Parts Discussed in Thread: AMC1301 , AMC131M03 , AMC1300 Any body can suggest a replacement for this AMC1210 ? Currently its not available.
Part Number: AMC1210 Dear TI support,
I'm designing the AMC1210 and AMC1106M for Thermal Coupling sensor. Designing of AMC1210 is with
SPI communication with 4MHz on SPI-1. And, Power supplys are, 5V: AVDD, 3.3V:BVDD,CVDD and DVDD,
GND: AGND. Other…
Part Number: AMC1210 Tool/software: Hi,
We have an AMC1210 in a resolver application. The device is in SPI mode and we have a FPGA with cusom VHDL to handle the ACK, read the interrupt register and then read the relevant filter registers.
We use…
Part Number: AMC1210 Other Parts Discussed in Thread: AMC3336 Tool/software: Dear TI Community, I an seeking support regarding strange data artefacts on measurements with the AMC1210.
AMC1210 is demodulating the output of AMC3336.
We have observed…
Part Number: AMC1210 Tool/software: Hello,
we use the AMC1210 with Interface Mode SPI by tying M0 and M1 to ground. How does the SPI interface (CS=CS, WR=CLK, RD=MOSI, AD0=MISO) act while the AMC1210 is in reset by tying RST to ground?
Does it react…
Part Number: AMC1210 Other Parts Discussed in Thread: AMC1204 I use AMC1210 with AMC1204 in a motor drive application for shunt current measurement.
I have exactly the same problem discussed in "AMC1210 unexpected values at zero crosses" https://e2e…
Part Number: AMC1210 Dear support forum,
I try to use the AMC1210 to measure a voltage for a longer period of time (~11ms). Therefore, I enable the integrator mode 1 and have a look into the registers every 2ms.
The clock frequency is 20MHz and…
Part Number: AMC1210 Hello,
My customer wants to receive data from AMC1210 using the F283xx series.
If you have any example code or references for this interface, please share.
Thank you.
JH
