Part Number: AMC1304L25 Other Parts Discussed in Thread: AMC1204 Hi teams
I am using AMC1304L25 (LVDS output) in the new design.
According to the datasheet, the LVDS output amplitude is about 350mV(Typical).
I wonder to know this value is the peak-to…
Part Number: AMC1304L25 Other Parts Discussed in Thread: AMC1305L25 Hi Experts,
We are using
AMC1304L25 Reinforced Isolated Modulator With LDO Regulator, ±250mV Input, and LVDS Interface fro one of our design. For performing Signal Integrity analysis…
Part Number: AMC1304L25 Other Parts Discussed in Thread: SN65LVDS051 , SN65LVDS180 Hello! Because the DSP (28377) and the power unit are far apart, they need to be connected by wire. Therefore, AMC1304L25 is selected and the digital interface is LVDS,…
Part Number: AMC1304L25 Other Parts Discussed in Thread: AMC1210 Hi everybody,
I'm using AMC1304L25 to measure DC+AC voltage, up to approx. 250V. Thus using large voltage resistor divider.
I designed a fully symetrical input stage to cope with issue…
Part Number: AMC1305L25 Other Parts Discussed in Thread: AMC1304L25 , Hello, Both AMC1304L25 and AMC1305L25 datasheets specifies only TYP value for “Differential input resistance” as 25Kohm. Is Min value for this parameter available?
Regards, …
Jian Li,
1) Data Acknowledge bit is set every time a new filter data is available. A new filter data is available every (DOSR / SD-Cx freq) secs. In your case, every (128/10MHz) = 128us.
2) This question can be best answered depending upon the ENOB…
Other Parts Discussed in Thread: AMC1304L05 , OPA376 , AMC1304L25 Hello,
I am evaluating the AMC1304L05 and AMC1304L25. Application report SBAA215 describes a possible solution to optimize offset and gain errors using an opamp at the input (OPA376 in this…
Still having problems to aquire the data from the ADC. When measuring Data pin with the oscilloscope I get a sequence of ones and zeros, but when I approach the saturation Voltage (+50mV for the AMC1304L05), I still see a similar sequence of ones and…
