Part Number: AMC1304M05 Tool/software: Hi,
Is it possible to set the OSR as 64 and operating at fclk = 20MHz and then use a sinc2 filter so that a group delay of as low as 3.2us can be achieved for this IC? Also, how much is the maximum data rate that…
Part Number: AMC1304M05 Hi,
Good Day. The customer is looking at the AMC1304M05 for measuring the current (low side) of a sine wave that swings +ve and negative at around 200KHz. Is this part suitable for low-side measurements? The min common mode voltage…
Part Number: AMC1304M05 Other Parts Discussed in Thread: AMC1306M25-Q1 Dear forum participants and/or TI support,
Would it be possible to get the topology and filter coefficients for the sigma delta modulator for modeling/simulation? The f2837xD SDFM…
Part Number: AMC1304M05 Other Parts Discussed in Thread: INA240 , AMC3306M25
Dear team:
I designed 2-Phase shunt current measurement circuit with two AMC1304M05 chips.
I have several question in my application.
1. what happened if AGND is…
HI Tom Hendrick
Front end input AC LIVE and GND_USH1 are connected, can not be connected? If the connection to the live is only a single-phase be controlled , the three-phase connection cannot be controlled at the same time
Hi Benjamin,
As noted in Figure 51 of the AMC1304M05 datasheet, the output will be either all ones or all zeros depending on the last known data state of the modulator. Your block diagram did not come through, but the SDFM filter would see this condition…
Part Number: AMC1304M05-Q1 Other Parts Discussed in Thread: TMS320F28075 , TIDA-01094 I will be measuring the inductor current in a dual interleaved boost converter and the inductor current of an inverter.
1) In the examples presented in datasheet of…
Part Number: AMC1304M05 Other Parts Discussed in Thread: AMC1210 Hi team,
I am helping customer to test AMC1304 together with C2000. Thus I am trying get some detailed knowledge on this devices.
When I am looking into the resolution of AMC1304, it…
Part Number: AMC1304M05AMC1304M05QDWRQ1 1000pcs purchased form Digikey , but the solderability is not qualified that tested by CEPREI .
Please informed me why the solderability is not qualified , thanks.
