Part Number: AMC1306M25 The application scenario is current sampling driven by motor servo，This is the diagram：
Encountered two problems：
There are burrs in the current sampled by the software when the motor is idling。
The sampling current of software…
Thanks for your reply. Customer tried implementing all the recommended suggestions but the saturation issue still persists. Please find their comments below.
1. When we individually test the IC with +/- 250mV at the inputs, we are getting the…
Part Number: AMC1306M25 Other Parts Discussed in Thread: AMC1305M25 , Hi,
in the datasheet of AMC1305M25 section 7.10 is shown Vclipping with 312.5mV Typ.
For AMC1306M25 it is shown with 320mV.
Are both values correct, if yes what's the reason for the…
1.) Both the AMC1204 and the AMC1306 should have the AGND (pin 4) of the device connected to the shunt. I don't believe that is specifically spelled out in the AMC1204 datasheet, but that is the general intention depicted in Figure 50 of the datasheet…
Part Number: AMC1306M25 Hi team,
What is the flammability rating of AMC1306M25? I didn’t find it in the datasheet. Do you have related materials?
Really appreciate your help!
Thanks & Best regards,
Other Parts Discussed in Thread: AMC1306M25 , AMC1204 The schematic diagram is as follows:
After sampling with AMC1306M25 oscilloscope test motor U phase and V phase waveform is as follows:
You can see spikes in both phases;
Same program and hardware…
Part Number: AMC1306M25 Hi BU:
I have one issue about the AMC1306M25 and need your help.
Customer evaluate the performance of AMC1306 in the high temperature. Please see the below picture.
The red is the actual current waveform , and blue is the sigma_delta…