Part Number: AMC131M03 Hi, comparing Figure 6-22 with the values in the table in Section 6.8, I guess the graph refers to the no load condition, with 2.9V at 25°C in HR mode. However, Figure 6-23 shows a graph that is not consistent with the table. For…
Part Number: AMC131M03 Other Parts Discussed in Thread: ADS131M03 Hello, referencing AMC131M03 datasheet revision A (Aug 2023), in the timing table tsu(SY) is noted as the "Setup time, SYNC/RESET valid before CLKIN falling edge". However figure 6.2 appears…
Part Number: AMC131M03 Tool/software: Hello Ti Team,
i have a big problem to configurate the AMC131M03 device.
I'm setting up the SPi communication with FPGA Xylinx Artix 7
ADC Clock 6.25 Mhz.
I'm sending at first 2 configuration frames. After…
Part Number: AMC131M03 Tool/software: I am trying to drive an AMC131M03 on an AMC131EVM card from a F28379D ControlCard.
The Precision Host Interface has been removed.
The F28379D ControlCard is connected via the J5 DEBUG terminals.
All the jumpers…
Part Number: AMC131M03 Other Parts Discussed in Thread: ADS131M04 Tool/software:
Hi in AMC131M03 using continuous conversion mode when data is ready the device will send 3 channels of data automatically out in DOUT pin, or we have to read individually…
Part Number: AMC131M03 Hello,
We are using the AMC131M03DFMR in a new product design and through our certification process it was discovered that the datasheet says "Pending" for inclusion of AMC131M03 in File E181974. Could you please provide a timeline…
Part Number: AMC131M03-Q1 Other Parts Discussed in Thread: ADS131M04 , AMC131M03 Tool/software: Hi, I'm using AMC131M03 and ADS131M04 for voltage and current sensing and measurements. are there any SPI driver files or any example file using SPI configuration…
Part Number: AMC131M03 Tool/software: Hi,
The clock frequency (fclk) for ADC provided for this part number in the datasheet is 8.192MHz and the maximum data rate of ADC is 64ksps. Is there any way this clock frequency can be increased so that faster…
Part Number: AMC131M03 We designed an application with AMC131M03 with current load less than 1mA applied on HLDO_OUT and a total capacitive load of about 3uF. We noticed a start-up voltage ramp of DCDC_OUT which has some oscillation before reaching the…
Part Number: AMC131M03 Other Parts Discussed in Thread: ADS131M04 Tool/software: Hi im using AMC131M03 IC, in that im facing an issue i have configured data for 16bits , dcdc enabled and OSR of 128 , all are working fine. but sometimes my crc is not matching…
