Part Number: AMC7834EVM I seem to be having an issue with the SENSE1 input on the EVM board. I have an input set up that will generate a 0-200mV signal, but the reading I'm getting on SENSE1 continuously bounces between 0 and a high value. If I connect…
It was detected as a generic COM device. After installing the driver you suggested it enumerates as a TI MSP430 COM device.
The behavior of the AMC7834EVM software hasn't changed. It still loads with the same message and then locks up.
Part Number: AMC7834EVM It seems that if there is an over voltage on either the ADC1-4 or SENSE1-4 inputs the ADC will set the registers to zero and indicate an alarm. Once the over-voltage is corrected the alarm clears, but the ADC does not trigger again…
Part Number: AMC7834EVM Other Parts Discussed in Thread: AMC7834 , LMP92066 Hello,
I want to set mode of closed loop operation.
can you please send an example of configuration file for this mode?
Any SW application note will great as additional…
Part Number: AMC7834EVM Other Parts Discussed in Thread: AMC7834 Team,
I use the interface board for the AMC7834 demo board to control the chip on my board. Currently I use your GUI to talk with the interface board.
My question is if I could talk…
Part Number: AMC7834EVM Other Parts Discussed in Thread: AMC7834 Hi Team,
I need some info on a request I received from my customer.
They want to use AM7C834EVM , but the software we provide on windows 10 is not working.
Can you suggest a solution…
Part Number: AMC7834EVM Other Parts Discussed in Thread: AMC7834 hi!
I have a few questions about ref_cmp.
case1
.in datasheet,the Pin REF_CMP connect a 4.7uf capacity to GND4
case2
In AMC7834EVM user's guide( slau608b ), The p in REF_CMP…
Part Number: AMC7834EVM I tried changing the DAC output but will it not update on the board. However, I can set the range and the output voltage will change to the range's minimum.
I'm using the external supply for the required voltages, using J11,…
Part Number: AMC7834 I have read the AMC7834 data sheet and the AMC7834EVM user guide and I see how to set the register to set up GPIO1 - GPIO4 as inputs or outputs. What I do not find is how to set up the functionality of these I/O. How are they utilized…
