Hi Todd,
Thank you for your reply.
I'm happy to also answer following question.
>Is AMIC120 supports all masking options in Hwi? If Hwi_A is masked by masking options in Hwi_B, is Hwi_A's interrupt ignored while Hwi_Bis running?
Regards, …
Hi Jason,
Thank you for your reply.
Biss-C gets position information of the rotating shaft of the motor.
eQEP directly counts the speed pulse output from AMIC120 for motor control.
Regards,
U-SK
Part Number: AMIC120 Hello.
In datasheet of revision A, it is described that EMAC is not supported.
But in datasheet of revision B, EMAC 1 port support is added.
Could you tell me the reason why datasheet of revision A said that EMAC is not supported…
Hi,
In order to interface with a sin/cos resolver you need a sinusoidal excitation source and then the ability to simultaneously capture the two analog voltages returning from the resolver.
A PWM peripheral (along with some external circuitry) could…
Part Number: AMIC120
Tool/software: TI-RTOS
Hello,
Is it possible to implement IO-Link master and EtherCAT slave(or any industrial network slave) to AMIC120 or AM437x at the same time?
I would like to develop IO-Link master to EtherCAT slave gateway…
Part Number: AMIC120 Hello,
If we want to use RTC and set RTC-Only mode, can we use internal clock source as RTC clock signal?
Is external oscillator or crystal needed?
Is there an internal oscillator that can also operate in RTC-Only mode?
Regards…
Part Number: AMIC120 Hello,
1.Does AMIC120 support following protocol?
CC-Link(RS485) / Devicenet / Modbus / CANopen
2.If TI does not provide the above software, are there any 3rd Party that can develop?
Regards,
U-SK
Part Number: AMIC120
Hi all,
Is it possible to support with Ethernet/IP on AMIC120 with the following SW?
software-dl.ti.com/.../index_FDS.html
I do not know because I did not mention AMIC120 when I looked at the link.
Best regards,
Sasak…
Part Number: AMIC120 Other Parts Discussed in Thread: CONTROLSUITE Team,
My customer is working on AMIC120 based EtherCAT+motor control design, and has a few questions, I hope you can answer:
Are there any drivers or design examples you’d recommend…
Hi,
TI provides examples for encoder protocols in the Industrial Drives package located here: software-dl.ti.com/.../index_FDS.html
The documentation for the package can be found here: processors.wiki.ti.com/.../PRU_ICSS_Industrial_Drives
As…
