Hello James,
I still have some questions on the topic:
- are the two outputs FMCW_CLKOUT and FMCW_SYNCOUT work exactly the same?
- and if we only have one slave device, do you know why the system works only if we use just one port and a splitter to have…
Part Number: AWR2243 n AWR2243 cascaded system, slave devices use external frame syn signal for frame trigger and this frame sync signal will route back to host. There is frame trigger delay after sync in pulse input to real frame start (chirp transmit…
Part Number: DCA1000EVM Other Parts Discussed in Thread: AWR2243 Hello,
I am using awr2243 with DCA1000 , mmWave Studio version mmwave_studio_03_00_00_14.
I am trying to control mmWavestudio from MATLAB as post processing is also being handled in MATLAB…
Part Number: AWR2243 Hi,
We utilize the AWR2243 in cascade mode and have observed a tendency for our sample signals to decay towards the end of the chirp, as illustrated in the image below. The chirp configuration was as follows: - Center frequency: 78…
Part Number: AWR2243 We’re currently developing a board using AWR2243 chip, I found rough info about internal calibration and internal monitors. If I understood well, these are my considerations/doubts:
Calibrations are several on TI AWR2243 chip…
Part Number: DCA1000EVM Hello,
I am trying to send record command to mmWave studio over Matlab. Since I am running my matlab script several times in a loop, I want to pass data path and file name for adc_data.
I tried the solution suggested in this t…
Part Number: AWR2243 Hello,
I collected data both with complex 1x mode and complex 2x mode and I want to plot the range FFT in both cases. With the same chirp configuration and general setup the range FFTs show the peak corresponding to the strongest…
Part Number: AWR2243 Other Parts Discussed in Thread: AWR1243 Hi,
When I test TX gain mismatch, I find the gian of TX2 is lower than other two TXs. The same thing happens with TX phase mismatch.
But I find some intresting info in " Monitoring…
Part Number: AWR2243 Other Parts Discussed in Thread: MMWCAS-RF-EVM Good afternoon supporter,
I have an AWR2243 MMWCAS-RF-EVM. the device was used to collect data in angle sweep TxBF. the data were stored in seperate foldes for each angle. The seperation…
Part Number: AWR2243 Other Parts Discussed in Thread: AM2732 Hi Experts
When we try to run official mmw demo on AM2732+AWR2243 EVM,
We find that when we are using below specific profile , there are peaks at the farthest ranges bin of 1D FFT which is not…