Part Number: BQ21061 Hi
I have problem to use i2c communication in active battery mode. I am pretty sure the LP pin is high.
At the moment, I can only access the I2C by for MR low. I don't have oscilloscope or possibility to access the I2C pin. Is there…
Part Number: BQ21061 Other Parts Discussed in Thread: TPS22916 Dear,
I have a question as in https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1104591/bq21061-reverse-voltage-to-the-ldo-of-bq21061?tisearch=e2e…
Part Number: BQ21061 Other Parts Discussed in Thread: BQ25120A Hello,
Our company is interested in using the BQ21061 for our design, however, we are concerned about this device not having non-volatile memory for the charging configurations. For our application…
Part Number: BQ21061 Hi expert,
My customer wants to use VDD as a 1.8V source.
May we know that how much current could VDD pin support?
Thank you.
Best Regards,
Cindy
Part Number: BQ21061 Hi, I have question on BQ21061EVM board. I put the board in to ship mode but I still get quiescent from battery port around 7.5mA. PMID is 0V, Vin is disconnected, and I measure the current by putting current meter in series with…
Part Number: BQ21061 Hello,
I would like to use BQ21061 in our application to recharge a Li-ion battery in which I intend to connect our micro(host) to the LDO output. At the first power up BQ21061 has the LDO output at 1.8V that is sufficient to wake…
Part Number: BQ21061 Dear
I'm designing a battery charger with your BQ21061 IC and protection circuit with your BQ29707 to recharge a small capacity (about 30mAh) Li-Ion battery. Inside the datasheet of the battery I found that the battery must not be…
Part Number: BQ21061 Dear,
I would like to know if we can routing out the /INT pin of BQ21061 connecting this pin to NC1 and NC2 pins avoiding via-in pad solution. From your application note "Slua996" I understand that it is possible to routing out the…