Part Number: BQ24041 Other Parts Discussed in Thread: BQ24040 Tool/software: Hi,
We are evaluating the BQ24041 and have a few questions.
1. Can you provide normal distribution data for VOUT(REG) for the BQ24041?
2. The VOUT(REG) specification for…
Part Number: BQ24041 Other Parts Discussed in Thread: BQ24040 , , BQ24072 Hi.
For a project we are considering change the BQ24040 and place the BQ24041.
In the project we have we need to have an output with and without a cell connected to the output…
Part Number: BQ24041 Dear team
The product of bq24041 (Scooter IOT application) has been burnt out recently.
The burned-out place is the Vout of the charger, please refer to the figure below. Because BQ24041 itself also has short and thermal protection…
Part Number: BQ24041 Hello, we boughts a few thousands of BQ24041DSQR from your online store - so we can exclude a problem of fake / conterfeit chips. However, approx. 5% of the chips are not working properly, on a stable project where we didn't have…
Part Number: BQ24041 Other Parts Discussed in Thread: BQ24040 , TPS22914 Dear TI-Team,
here:
Bill stated that PG can be connected to EN with a pull up... why would we need a pull up (given there's no external host)?
If we actually need a pull…
Hello
The BQ24041 BAT_EN pin can be tied to ground, device will be in constant enable condition.
Using the PG pin with pull up connected to BAT_EN will work also.
Both solutions are good.
Part Number: BQ24040 Other Parts Discussed in Thread: BQ24041 I now design a low-power BQ24040 charging circuit, I want to know, if I don't have to TS temperature detection, I used a 10 k resistor connected to TS to the ground, and then use MCU control…
Part Number: BQ24040 Other Parts Discussed in Thread: BQ24041
I've used the BQ24041 with success on previous designs. However, I have a new board that does not charge the battery. The battery is LIP 3.7V 500mAh. I connected the battery to a different…
