Part Number: BQ24061 Hello Expert,
This application is Gas Detector.
Gas Detector has to protect explosion internally.
So they have to use diode or FET to protect reverse voltage from batter to charger Pin10(Out) when there is no power to charger…
Part Number: BQ24061 Hi
My customer is using BQ24061.
No battery condition, LED is not off, so 2.2M resistor inserted between Vout and GND as shown in the circuit.
No battery status, LED off.
However, removing the battery, as shown in the video…
Part Number: BQ24061 Hi Expert,
I found the difference between package image of bottom and package dimension like below.
How do I make PCB Library?
Could you please give me right information?
* Package image
* Package Outline
Best Regards…
Other Parts Discussed in Thread: BQ24061 I have an application that will consist of (mainly) a BQ24061, a lithium battery pack consisting of 2-4 18650 cells in parallel and a GMS modem. The intended design is to have the BQ charge the battery and the…
Other Parts Discussed in Thread: BQ24061 Dear Sir
Good days,
I have get BQ24061 EVB and have one question need your help.
When I add 5V power source to BQ24061 EVB and no put bettery, this status STAT1/STAT2 should be "off".(from DS table 3)
But…
Other Parts Discussed in Thread: BQ24061 Hi
I have a charger which uses the Li-ion linear charger, BQ24061. I am precisely using the application circuit on page 12 of the datasheet (Figure 16: Application Circuits, the second one which corresponds to…
The Data Sheet and the EVM show different connections from Vbat to Vout.
One shows a 200 ohm resistor the other shows a hard connection or 0 ohm connection.
When is the 200 ohm resistor needed?
Part Number: BQ24064 Other Parts Discussed in Thread: BQ24061 , BQ24088 , BQ24085 , BQ24010 , BQ24014 , BQ24012 , BQ25611D Hi, Customer has to insert a diode between the OUT pin and the battery for application reasons. I will attach an image diagram.…
