Search tips
Showing 18 results View by: Thread Post Sort by

  • BQ24086: the date code on the reel label is not consistent with the date code on the inner box and MBB package

    Part Number: BQ24086 Tool/software: the date code on the reel label is not consistent with the date code on the MBB package. any reason to cause this kind of phenomenon?

  • BQ24086: Not start charging

    TI Thinks Resolved
    Part Number: BQ24086 Other Parts Discussed in Thread: BQ2057 Hello Jeff， I found that BQ24086 EVM can’t start charging the battery if the output load is more than 15mA. BQ24086 will enter short circuit protection.I can’t understand phenomenon according…
    • Answered

  • BQ24086: About TS pin

    Resolved
    Part Number: BQ24086 Hi, Could you tell me about TS pin ? Customer wants to install a ceramic capacitor to deal with noise on the TS pin. 1. EVM is set to 0.01 μF. 　What is the maximum capacity that can be installed? 2. Is the management by the TS pin…
    • Resolved

  • BQ24086: Charger Status Pins On Full Battery Charge

    TI Thinks Resolved
    Part Number: BQ24086 Hi, We are using BQ24086DRC as charger IC for our lithium-ion batteries. The issue is when instrument is put on charger for long duration (10-12) hours after full charge, the charger status pins start giving the "charge fault" status…
    • Answered

  • BQ24086: Charge status

    Resolved
    Part Number: BQ24086 Hello, How does the STAT1 pin of bq24086 behave when USB Bus power is applied once after terminate of charging the battery? Best regards, Hiroaki
    • Resolved

  • BQ24086 Temp Issue

    Other Parts Discussed in Thread: BQ24086 Hi. Tiers. When bq24086 is below condition, bq24086's top temp is 36C (Amb. temp is 26C). I think this temp(36C) is very high becuase charge current is low (100mA). This temp is normal? If you have temp…

  • BQ24086's Resister

    Hi. Tiers. As below description on datasheet, when I(out) < 200mA, 390 ohm(R8) is recommended. And I am going to set I(out) = 100mA. I want to know what is role this resister (R8=390ohm). Please let mw know ASAP. Thanks.
    • Answered

  • BQ24086 indicate in recharge

    Resolved
    Other Parts Discussed in Thread: BQ24086 Hi, Is STAT1/2 operation on recharge mode same as it on normal charge mode? customer will connect red led to STAT1 and green to STAT2. After full charge, green will turn on. When BQ24086 goes to recharge…
    • Resolved

  • BQ24086's battery absent detection waveform in datasheet

    Other Parts Discussed in Thread: BQ24086 Hi Tiers. In BQ24086's datasheet, there is below battery absent detection waveform figure. In this waveform, when I_DET is applied, Vout voltage is almost 4.5V. BQ24086's charging voltage is 4.2V. What…
    • Answered

  • bq24086 ESD rating

    Resolved
    Other Parts Discussed in Thread: BQ24086 Hi, Can you please advise what the ESD rating is for the bq24086 charge management IC? Thanks, John
    • Resolved

Didn't find what you are looking for? Post a new question.