Other Parts Discussed in Thread: BQ24192I Hello,
I use bq24192I with PSEL=LOW.
And I don't use Boost mode.
In this case, please tell me the usage of the OTG-terminal.
High or Low or Open?
Table3 of P15 of SLUSAW5B describes OTG as "-".
Regards…
Other Parts Discussed in Thread: BQ24192I Dear Sir
When I insert adapter to my system and finish to program register of BQ24192I
And then I replug my adapter ,but I find only the register of input current limit will be changed to default value …
Part Number: BQ24192I Other Parts Discussed in Thread: BQ25896 , PMP11536 , PMP4496 , BQ25895 , BQ24192 Hi,
I have been looking at the BQ24192I charger which I want to use in a battery powered application with only an USB Type-C USB 2.0 connector as…
Other Parts Discussed in Thread: BQ24192I Hi,
We are planning to use BQ24192i in one of our design and using a Single cell battery in system. We are feeding the output of BQ24192i (VSYS) to input of Power Management chip which has input range 3.5V-5…
Other Parts Discussed in Thread: BQ24192I , BQ24192 What can be done to use the BQ24192i with a 4 V input voltage? By default the VINDPM[0...3] is 0111 corresponds to a minimum input voltage of of 4.44 V. I would like this to be 0000 so that the minimum…
If anyone knows, please tell me how to configure the SW ( system out) pins voltage to 3.5V in this chip?
Also it is possible to know if its okay to connect my Solar Pannel to the Vbus pin? I wish to use this IC in a tracking device.
thank you so…
Part Number: BQ24192 Other Parts Discussed in Thread: BQ24190 , , Tool/software: Hello, the datasheet for this device states: For safe operation, the bq24190, bq24192, bq24192I has an additional hardware pin on ILIM to limit maximum input current on ILIM…
Hi Amos,
For VBUS only operations without battery, please refer to the FAQ below. Hope it helps.
https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1022791/faq-bq25890-why-does-the-led-connected-to-stat-pin…
Hi,
For BAT pin open condition for BQ24195, please refer to the FAQ below.
https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1022791/faq-bq25890-why-does-the-led-connected-to-stat-pin-flashes-and-the-sys-voltage…
