Part Number: BQ24230 Dear Mr./Mrs.:
I could not find in the datasheet the termination current threshold for the bq24230. So, please, could you tell me the % of I charge current?
Thank you
Part Number: BQ24230 Tool/software: Hi Team,
There are CHG status issues on 2 use cases of no input power with battery and valid input power without battery. I think that CHG status should be high-impedance on 2 use cases, but the status is low(about…
Part Number: BQ24230 Tool/software: Hi Team,
I'd like to ask you about the schematic design review. The setup conditions are ISET=500mA, ICHG=245mA(0.7C), Battery=Li-Polymer 3.7V@350mAh, TMR=not used. Please check the attachment below and let me know…
Part Number: BQ24230 I have a custom design with the BQ24230 with these values: ILIM resistor: 3.06K ISET resistor: 30K EN2: 1 EN1: 0 When putting a multimeter to measure the current going to IN, I get .87mA. I don't understand, based on the calculations…
Part Number: BQ24230 We do the deep discharge while one night without adaptor input. We find the VBAT become unstable after I insert the adaptor 5Vdc. The VBAT and IBAT show in below.
I know the Vlowv is the same as battery cut-off voltage. But the…
Part Number: BQ24230 Other Parts Discussed in Thread: BQ24232 Dear Mr./Mrs.:
We are using the BQ24230 with VIN= 5VDC nominal and PIN 15 connected to VSS. We would like to replace it by the BQ24232 with PIN15 connected to VSS for a direct replacement…
Part Number: BQ24232 Other Parts Discussed in Thread: BQ24230 Dear Mr./Mrs,
If input voltage is not a constraint, I would thank your confirmation about the bq24232 repalcement of bq23230 in the circuit below (pin15 connected to ground)
Many thanks…
Part Number: BQ24075 Other Parts Discussed in Thread: BQ24230 , BQ24073 , BQ24074 Dear Mr./Mrs.:
I would like to know if the BQ24075 IC is a direct repalcement of the BQ24230 with PIN15 connected to VSS on both cases.
Many thanks in advanced
Part Number: BQ24230 Dear TI,
I developing the Battery charge with BQ24230.
The after finish charging with keep inserted USB cable, when do the start recharging?
Sincerely Yours
Seok
Part Number: BQ24230 Other Parts Discussed in Thread: BQ24232H Hi,
Does BQ24230 have ready RTM? I can't find this part on TI website.
And for 4.35V battery charge. I can use BQ24232H, right?
Seem only pin15 is different?
Thanks!
Jeff
