Part Number: BQ24292I Tool/software: For our product implementation, we can use it with or without a battery connected. The issue in this thread is specific to the implementation without the battery.
During non-battery operation we set the BATFET_disable…
Part Number: BQ24292I
Tool/software:
I have a setup with the following schematics: VIN is the Vbus of an USB-C Port to which the device is the peripheral/device, never the host. Now what I am trying to do, is to disconnect the Battery (via I2C host…
Part Number: BQ24292I Tool/software: Hi,
We have the following scenario in one of our implementations:
The unit are connected to a 5V supply which can only supply 500mA. The charger IC also set the current limit to 500mA.
When the unit is running…
Part Number: BQ24292I Other Parts Discussed in Thread: EV2400 Tool/software: We have been seeing an issue with reporting of the Charge Safety Timer fault. We've run three separate tests using experimental charging microcontroller (MCU) FW that sets the…
Part Number: BQ24292I Battery connected: 10000mAh full charged (4.2V). I turn off VBUS supply. Maximum current on VSYS output is 0.9A. I need at least 3A. Registers are set as follow:
static const uint8_t bq2429x_initial[] = {0x3F, 0x11, 0xFC, 0x11…
Part Number: BQ24292I Other Parts Discussed in Thread: BQ28Z610-R1 Hi, TI expert
There is an inquiry from a customer regarding BQ24292IRGER (Charger IC) / BQ28Z610-R1 (Fuel Gauge).
Q1) Currently, BQ24292IRGER (Charger IC) and 1-Cell (4.2V SDI Cell…
Part Number: BQ24292I Hi Team,
The E2E thread below shows a screenshot of electrical specs of the BQ24292I REGN LDO where in the typical output voltage is 5V. It is also stated that the REGN LDO is basically a 5V LDO.
https://e2e.ti.com/support/power…
Part Number: BQ24292I Hi Team, Can you please help us with our customer's inquiry below.
I have a board with this charger. Yesterday I charged battery to 100% (reported by fuel gauge) and I left it to discharge during the night. The configuration…
Part Number: BQ24292I Dear Team,
I was Tested bq24292i IC based Charger PCB with the following setups,
1.Instead of battery,i used Keithley 2380-120-60 DC electronic load in constant voltage mode
2.Power supply of DC source 5V, IA at Vbus and ground…
Part Number: BQ24292I Dear TI Team,
I was Tested bq24292i IC based Charger PCB and /CE is not grounded and ILIM pin is grounded through a 220 ohm resistor. We are getting a voltage at System output of 3.6 Volt and Vbat output of Zero volt. I connected…
